Sony DVP-C660 Operating Instructions - Page 58

Settings and Adjustments Settings for the Sound (AUDIO SETUP) x DTS Selects the DTS signals to be output via the DIGITAL OUT OPTICAL and COAXIAL connectors. You cannot select this item when you set "DIGITAL OUT" to "OFF." • OFF: when the player is connected to an audio component lacking a built-in DTS decoder. • ON: when the player is connected to an audio component having a built-in DTS decoder. If the player is connected to an audio component lacking a built-in DTS decoder, do not set this. Otherwise, when you play the DTS sound track, a loud noise or no sound will come out from the speakers, affecting your ears or causing the speakers to be damaged. Controlling your TV or AV Receiver (Amplifier) with the Supplied Remote Z If you adjust the remote signal, you can control your TV or AV receiver (amplifier) with the supplied remote. Default setting is to control Sony TVs with the mark. Number buttons TV 123 456 789 0 TV @/1 Controlling TVs or AV receivers (amplifiers) with the remote Hold down TV @/1, and enter your TV's or AV receiver's manufacturer's code (see the table) using the number buttons. Then release TV @/1. Code numbers of controllable TVs or AV receivers (amplifiers) If more than one code number is listed, try entering them one at a time until you find the one that works with your TV or AV receiver (amplifier). Notes • If you enter a new code number, the code number previously entered will be erased. • When you replace the batteries of the remote commander, the code number is reset to 01 (Sony TVs). Reset the appropriate code number. 58