Sony HC1000 Camera Operations Guide - Page 28
To monitor the sound during recording, 4CH Audio Check, To adjust the volume of recording sound - headphones
UPC - 027242654853
View all Sony HC1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
To monitor the sound during recording - 4CH Audio Check You can listen to either the front input sound or the rear input sound. Using headphones is recommended (p. 131). 1 Touch . 2 Touch [MENU]. 3 Select (STANDARD SET) menu, then [4CH AUD CHECK] by touching / , and then touch . 4 Select [FRONT] or [REAR], then touch . When [FRONT] is selected: The front input sound is heard. When [REAR] is selected: The rear input sound is heard. To adjust the volume of recording sound You can adjust the volume of the front and rear input sound. Using headphones is recommended (p. 131). 1 Touch . 2 Touch [MIC LEVEL]. If the item is not displayed on the screen, touch / . If you cannot find it, touch [MENU], and select it from the (STANDARD SET) menu. 3 Touch [MANUAL]. 60min MIC LEVEL: 30 FRONT REAR STBY 0:00:00 MANUAL 20 12 0 dB AUTO MANUAL OK 4 Touch / to adjust the volume. The front and rear sound volumes cannot be adjusted separately. 5 Touch . To check the recorded sound You can check the recorded front and rear sound after recording. 1 Slide the POWER switch repeatedly to select the PLAY/EDIT mode. 2 Touch . 3 Touch [AUDIO MIX]. If the item is not displayed on the screen, touch / . If you cannot find it, touch [MENU], and select it from the (STANDARD SET) menu. 60min AUDIO MIX 0:00:00:00 ST1/ FRONT ST2/ REAR 4 Adjust the balance of the front and rear sound with / , then touch . The front sound can be heard at the end, and the rear sound at the end. Your camcorder cannot output 4ch audio simultaneously as it only supports 2ch audio output. When you set the audio balance bar to the center, the front and rear sounds are output at equal level. The adjusted audio balance returns to the default setting in about 5 minutes after the battery pack or other power sources have been disconnected. To end 4CH MIC REC Disconnect the microphone cable after finishing recording and after turning the power off. 28 Recording