Sony HWSBTA2W Operating Instructions - Page 16
Pairing, detecting it. When the BLUETOOTH connection is made properly, both - bluetooth transmitter
UPC - 027242695054
View all Sony HWSBTA2W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Pairing Check the following before operating the unit. - The TX/RX switch is set to "TX." - This unit is connected to a power source and the 1 indicator (green) goes off. 1 Press and hold the ID SET button for 7 seconds or more. When the 1 indicator (green) and indicator (blue) start flashing together, release the button. This unit enters pairing mode. Note Pairing mode is canceled and this unit is turned off after about 5 minutes. If this unit is turned off while performing the procedure, start over from step 1. 2 Set the BLUETOOTH stereo audio receiving device to pairing mode. This unit searches the BLUETOOTH stereo audio receiving device automatically, and pairs the device. This unit tries to connect the BLUETOOTH stereo audio receiving device soon after detecting it. When the BLUETOOTH connection is made properly, both the 1 indicator (green) and indicator (blue) light up, indicating pairing is complete, and pairing information is memorized on this unit. Notes • When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other. • Passcode of this unit is fixed to "0000." When using this unit as a transmitter, this unit cannot be paired with a BLUETOOTH stereo audio receiving device whose Passcode is not "0000." * Passcode may be called "Passkey," "PIN code," "PIN number," or "Password." If pairing is not complete Start over from step 1. Tip To pair with other BLUETOOTH devices, repeat steps 1 to 2 for each device. Note BLUETOOTH connection may be made on some devices automatically when pairing is complete. In such a case, both the 1 indicator (green) and the indicator (blue) light up, indicating that the BLUETOOTH connection has been made. 16 US