Sony KDL-60NX801 Setup Guide (Operating Instructions) - Page 6
Setting up your TV, Attaching the Table-Top Stand - model number
View all Sony KDL-60NX801 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Setting up your TV Some TV models are packaged with a detached Table-Top Stand so you can mount your TV to a wall right away. If you are not mounting the TV to a wall, you will need to attach the TableTop Stand. You will need a Phillips screwdriver and the supplied screws to complete the task. Look for the attachment instructions provided with the TV. Be sure to consider the following while setting up your TV: • Disconnect all cables when carrying the TV. • Carry the TV with the adequate number of people; larger size TVs require two or more people. • Correct hand placement while carrying the TV is very important for safety and to avoid damage. Attaching the Table-Top Stand Refer to the supplied Table-Top Stand instruction leaflet for proper attachment for some TV models. ~ • Do not put stress on the LCD panel or the frame around the screen. • Be careful to not pinch your hands or the AC power cord when you install the TV unit to the Table-Top Stand. For KDL-52/46NX800 and KDL-46/ 40NX700 1 Gently slide the TV unit onto the Table-Top Stand and align the screw holes. • Ensure your TV has adequate ventilation, see page 16. • For best picture quality, do not expose the screen to direct illumination or sunlight. • Avoid installing the TV in a room with reflective wall and floor materials. • If the TV is brought directly from a cold to a warm location, or is placed in a very damp room, or is placed in a room in which heating has just been turned on, moisture may condense on the surface or inside the TV. Should this occur, turn off the TV and leave the TV off until the moisture evaporates, and then the TV can be used. If you notice moisture condensation between the glass panel and the LCD, turn on the TV and the condensation will evaporate after the TV has warmed up. 6 2 Use the supplied screws to attach the TV unit to the Table-Top Stand. ~ • If you use an electric screwdriver, set the tightening torque at approximately 1.5 N·m {15 kgf·cm}. 3 After all the screws are tighten cover the Table-Top Stand with the supplied Stand Rear Cover.