Sony KV-32HV600 Operating Instructions - Page 84
Channels, General, Cannot operate Menu - 7 blinks
View all Sony KV-32HV600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Welcome SETUP SETUP Channels Problem Cannot receive upper channels (UHF) when using an antenna TV is fixed to one channel Cannot receive any channels when using cable TV Cannot receive or select channels Possible Remedies ❏ Change the Cable option to Off (see page 68). ❏ Use Auto Program in the Channel Menu to add receivable channels that are not presently in the TV's memory (see page 68). ❏ Use Auto Program in the Channel Menu to add receivable channels that are not presently in the TV's memory (see page 68). ❏ Check your Channel Fix settings (see page 68). ❏ Use Auto Program in the Channel Menu to add receivable channels that are not presently in the TV's memory (see page 68). ❏ Make sure the Cable option is set to On in the Channel Menu (see page 68). ❏ Use Auto Program in the Channel Menu to add receivable TV channels that are not presently in TV memory (see page 68). General Problem Possible Remedies How to reset TV to ❏ Turn on the TV. While holding down the RESET button on the remote factory settings control, press the POWER button on the TV. (The TV will turn itself off, then back on again.) Release the RESET button. How to restore Video settings ❏ Press the RESET button on the remote control while in the Video Menu (see to factory settings page 64). How to restore Audio ❏ Press the RESET button on the remote control while in the Audio Menu (see settings to factory settings page 66). Cannot cycle through the ❏ Be sure the Video Label option is not set to Skip (see page 75). other video equipment connected to the TV Cannot operate Menu ❏ If a menu option appears in gray, this indicates that the TV is in a state in which the menu option is not available. Lost password ❏ In the password screen (see page 70), enter the following master password: 4357. The master password clears your previous password; it cannot be used to temporarily unblock channels. TV makes "popping" sound ❏ This is a normal sound that results from the TV automatically degaussing when turned on each time it is turned on. LED on front panel is lit ❏ The STAND BY LED (see page 11) blinks when the TV is turned on, then shuts off when the picture is displayed. If the LED blinks continuously, this may indicate the TV needs service. ❏ The TIMER LED (see page 11) indicates that the timer is set (page 73). When the timer is set, this LED will remain lit even when the TV is turned off. SETUP SETUP Other Info 83