Sony MHC-MG110 Operating Instructions (primary manual) - Page 13

Getting Started/CD The disc number* at the loading position appears in the display. As you turn DISC ACCESS, the disc number or Disc Memo changes. * If you have already loaded discs, the disc number at the playing position appears. When you turn DISC ACCESS, the displayed disc number changes to the one at the loading position. Disc number 5 Close the front cover by pushing the right edge of the cover until it clicks. Total number of tracks and total playing time 3 Insert a disc with the label side facing right. Notes • Make sure you have loaded the disc into each slot at a right angle to the rotary table. If the disc is not put in straight, it may damage the unit or the disc. • Make sure the rotary table comes to a complete stop before loading or removing discs. With the label side facing right 4 Repeat steps 2 and 3 to load additional discs. The rotary table turns and the disc slot at the loading position is set to the playing position. Removing CDs After following step 1 of "Loading a CD" on page 12, remove the discs. Then close the front cover. Notes • Always close the front cover except when you load or remove discs. • Do not load an empty 8 cm CD adaptor. It may damage the unit. • Do not attach anything such as seals or sleeves to CDs. It may damage the unit or the disc. • If you drop a disc into the unit and the CD will not go into the slot correctly, consult your nearest Sony dealer. • When transporting the unit, remove all discs from the unit. • If you want to remove the disc played, open the front cover. The disc comes to the loading position. Remove the disc after the rotary table comes to a complete stop. Tip You can display the original Disc Memos instead of the disc numbers (see "Labeling a CD" on page 16) to locate the disc easily when you start playing. When you select a CD-TEXT disc, the disc title is displayed instead of the disc number. 13