Sony PCV-E302DS VAIO User Guide (Large File - 88.98 MB) - Page 1028

3. Shut down your computer and turn off all peripheral devices, such as your printer, display, and speakers. Unplug your computer. 4. Remove the left-side and bottom panels, as described on pages Removing the Left-Side Panel through Removing the Bottom Panel, respectively. 5. Install the new battery with the plus (+) side up. There is danger of explosion if you replace the battery incorrectly. You must replace the battery only with a CR2032 type lithium battery. Discard used batteries according to the instructions on On Disposal of the Lithium Battery. 6. Replace the bottom and left-side panels, as described on pages Replacing the Bottom Panel and Replacing the Left-Side Panel, respectively. The values stored in the CMOS memory are now reset to the factory default values. You must run the Setup utility to reset the date, time, passwords, and other options. See the VAIO MicroTower Reference Manual for details. 7. To run the Setup utility, press F3 when your computer is starting up. Then press F1 to run the BIOS setup utility. 8. Change the default values to the values you wrote down in step 2. 9. Save your Setup changes, and then exit the Setup utility. Installing an Internal Hard Disk Drive Your VAIO MicroTower comes with an available bay to hold an additional hard disk drive. The drive you install must not require front panel access. The hard disk drive access light blinks when either internal drive is active. Before opening the system unit, save any open files, exit Windows, turn off the power of the computer and all attached peripherals, and then unplug the power cord. 1. Configure the jumpers on the new drive as a secondary master (see your drive's documentation Page 1028