Sony PCV-RX755 Safety Information - Page 4

SAFETY INFORMATION AND CAUTION Your computer's installed optical drives may vary, depending on the system configuration you have purchased. See the Specifications sheet for details on your installed optical drives. DVD-RW Laser Diode Properties Laser Output Wave Length 0.39 mW (CD-Read) 0.18 mW (DVD-Read) 2.58 mW (DVDWrite) 11.5 mW (CD-Write) 650-662 nm (DVD) 773-797 nm (CD) DVD-ROM Laser Diode Properties Laser Output Wave Length 0.7 mW (DVD) 0.4 mW (CD) 635-665 nm (DVD) 770-810 nm (CD) CD-RW Laser Diode Properties Laser Output Wave Length 1.0 mW (Read) 53.0 mW (Write) 780-787 nm CD-ROM Laser Diode Properties Laser Output Wave Length 4 1.0 mW 760-810 nm ❑ To prevent fire or shock hazard, do not expose your desktop to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. ❑ Never install modem or telephone wiring during a lightning storm. ❑ Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. ❑ Never touch uninsulated telephone wire or terminals unless the telephone line has been disconnected at the network interface. ❑ Use caution when installing or modifying telephone lines. ❑ Avoid using the modem during an electrical storm. ❑ Do not use the modem or a telephone to report a gas leak in the vicinity of the leak. ❑ The socket outlet shall be installed near the equipment and shall be easily accessible. To change the backup battery, please contact your nearest Sony Service Center. Caution: The use of optical instruments with this product will increase eye hazard. As the laser beam used in this product is harmful to the eyes, do not attempt to disassemble the drive cabinet. Refer servicing to qualified personnel only. Danger: Visible and invisible laser radiation when open. Avoid direct exposure to beam. For CD-RW: Danger-Invisible laser radiation when open. Avoid direct exposure to beam. For DVD-RW: Danger-Visible and invisible laser radiation when open. Avoid direct exposure to beam. Caution: For ADSL, HomePNA and V.90 modem models; to reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.