Sony RM-AX4000A Instruction Manual - Page 71
Troubleshooting, Trouble with the Remote Commander's basic settings, Trouble with operation mode
UPC - 027242701205
View all Sony RM-AX4000A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Troubleshooting If you have problems setting up or using the Remote Commander, first check the batteries (page 10), then check the items below. Trouble with the Remote Commander's basic settings Problem The Remote Commander does not turn on. The LCD display turns off automatically. The beep does not sound. The touch-keys do not work properly at the right position. The LCD display does not light up even though the Remote Commander is turned on. XPRESS function does not perform On-Remote Setup. Solution Check the remaining battery level. If low, replace with new ones. The Remote Commander is preset at the factory to turn the display off automatically if you do not operate for more than 5 minutes. You can reset the automatic-off time to 1-30 minutes (page 34). The beep is turned off. Turn the beep on (page 41). Calibrate the alignment of the LCD display (page 39). The contrast level is too low. Set the contrast of the LCD display higher. While pressing the COMMANDER OFF button, press the OK button. And then press the CHANNEL + button a few times to increase the contrast. In case of On-Remote Setup, XPRESS function controls only the power on/off of the component. If you want to control the input selector of the TV, etc., follow the procedure for On-PC Setup. Additional Information Trouble with operation mode Problem The components I want to operate do not work even when the keys on the Remote Commander are pressed. The audio/visual component's volume is not controlled by the Remote Commander. Solution • Get closer to the component. The maximum operating distance is approximately 32.8 ft. (10 m). • Check that you are aiming the Remote Commander directly at the component, and that there are no obstructions between the Remote Commander and the component. • Turn on the components first, if necessary. • Check that the component has infrared remote capability. For example, if your component did not come with the Remote commander, it probably is not capable of being controlled by a Remote Commander. • If your visual components are connected to an audio component, For On-PC Setup: See the Help menu provided in "AX Remote Editor." For On-Remote Setup: See "Controlling the volume of visual components connected to an audio component" on page 57. • You have assigned another component to the Label key which was originally set as TV or RCVR at the factory (page 45). In this case, the volume cannot be controlled when you select a component other than TV or RCVR. Continued 71