Sony STR-DE898/B Operating Instructions - Page 11

Getting Started 2 Connect the video jacks. The following illustration shows how to connect a DVD player with COMPONENT VIDEO (Y, PB/CB/B-Y, PR/CR/R-Y) output jacks. Connecting a TV with component video input jacks allows you to enjoy higher quality video. DVD player OUTPUT VIDEO OUTPUT S VIDEO OUTPUT COMPONENT PR/CR/R-Y PB/CB/B-Y Y TV monitor INPUT VIDEO INPUT S VIDEO INPUT COMPONENT PR/CR/R-Y PB/CB/B-Y Y CD H CD H DIGITAL ANTENNA Y OPTICAL TV/SAT IN MD/ TAPE IN MD/ TAPE OUT SA-CD/ CD IN S-VIDEO S-VIDEO IN IN S-VIDEO S-VIDEO S-VIDEO PB/CB OUT IN OUT /B-Y AM PR/CR /R-Y VIDEO IN VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT L L L MONITOR TV/SAT DVD IN IN ASSIGNABLE MONITOR OUT COMPONENT VIDEO DVD IN SA-CD/ CD IN COAXIAL ASSIGNABLE (INPUT ONLY) SIGNAL GND L R IN IN PHONO SA-CD/CD R R R AUDIO IN AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN TV/SAT DVD VIDEO 2 VIDEO 1 L L L CENTER L R OUT IN MD/TAPE R R SURR SUB R SUB FRONT SURROUND BACK WOOFER OUT WOOFER MULTI CH IN 2ND ZONE PRE OUT + - CENTER SPE Tips • When using the S-video jacks instead of the video jacks, your monitor must also be connected via an S-video jack. S-video signals are on a separate bus from the video signals and will not be output through the video jacks. • On this receiver, standard video signals can be converted to component video or S-video signals and S-video signals can be converted to component video signals. These upconverted video signals can only be output from the MONITOR VIDEO OUT jack. However, you cannot convert the component video signals to standard video or S-video signals. • When standard video signals (composite video signals) or S-video signals from a VCR etc. are converted upward on this receiver and then output to your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image may be output. 11GB