Sony STR-DG1000 Operating Instructions - Page 118
Tuner, Remote control, Recording cannot be carried out.
UPC - 027242699908
View all Sony STR-DG1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
The image of the COMPONENT VIDEO OUT is corrupted. • When the signals are output from the COMPONENT VIDEO OUT jack, input signals other than 480p are corrupted if "PROGRESSIVE OUT" is set to "ON." Set "PROGRESSIVE OUT" to "OFF." • Video input signals other than 480p component are not received when signals are output from the S VIDEO jack or the VIDEO jack. Input 480i component video signals. • When component input signals other than 480p are output, use the COMPONENT VIDEO OUT jack and set "PROGRESSIVE OUT" to "OFF." The source image input from the HDMI jack is not output from the receiver or the TV speaker connected to the receiver. • Make sure that cables are correctly and securely connected to components. • Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component. Recording cannot be carried out. • Check that the components are connected correctly (page 24). • Select the source component using INPUT SELECTOR (page 48). Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe. 118GB Outdoor FM antenna (aerial) Receiver To ground Ground (earth) wire (not supplied) Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning. • Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 82). • Press DISPLAY so that the frequency appears on the display. Remote control The remote does not function. • Point the remote at the remote sensor on the receiver. • Remove any obstacles in the path between the remote and the receiver. • Replace all the batteries in the remote with new ones, if they are weak. • Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 38).