Sony VPL FX40 Operating Instructions - Page 20

Projecting 7 8 8 2 4 6,7,8 4 Press the INPUT key to select the input source. You can select directly the input signal you want to project by pressing one key from among INPUT A, B, C, D or E on the Remote Commander. Each time you press the INPUT key on the control panel, the input signal switches as follows: Input-AtInput-BtInput-CtInput-DtInput-E 1 Rear remote control detector COMMAND OFF ON INPUT A INPUT D INPUT B INPUT E INPUT C AIR SHOT VIDEO S VIDEO MENU APA ENTER 8 RESET FOCUS ZOOM SHIFT ASPECT KEY STONE 2 4 6,7,8 8 7 1 Plug the AC power cord into a wall outlet, then connect all equipment. The ON/STANDBY indicator lights in red and the projector goes into standby mode. 2 Press the ?/1 key. The ON/STANDBY indicator flashes in green, and then lights in green. 3 Turn on the equipment connected to the projector. S-VideoTVideoT To input from Press INPUT to display Computer, etc. connected to the INPUT A connector Input-A Computer, etc. connected to the INPUT B connector Input-B Computer/VCR, etc. Input-C connected to INPUT C connector Computer/VCR, etc. Input-D connected to INPUT D (Digital) connector Computer connected to Input-E LAN to use the network presentation function Video equipment Video connected to the VIDEO input connector Video equipment connected to the S VIDEO input connector S-Video Smart APA (Auto Pixel Alignment) adjusts the picture of the connected equipment so that it is projected clearly. Notes • If "Auto Input Search" is set to "On," the projector searches for the signals from the connected equipment and displays the input channel where the input signals are found. 20 Projecting