TP-Link T1500-28PCT TL-SL2428P T1500-28PCT V1 Quick Install Guide - Page 22

Smart PoE Switch Chapter 4 Connection 4.1 Ethernet Port Please connect the Ethernet ports of the switch to the network devices by RJ45 cable as the following figure shown. RJ45 Port RJ45 Cable Figure 4-1 Connecting the RJ45 Port 4.2 SFP Port Connect the SFP port to an SFP module. For the switch, if an SFP transceiver (purchased separately) is installed in a slot and has a valid link on the port, the associated RJ45 port will be disabled and cannot be used. SFP Port SFP Module Figure 4-2 Connecting the LAN Port Note: ■■ SFP module supports hot-plugging, plug the SFP module into the SFP port and the switch can identify it automatically. ■■ The SFP port supports 100/1000Base-FX SFP module at full-duplex mode. When using an SFP module, you need to log on to the GUI of the switch and configure the corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP mode is 1000MFD. 16 Connection