TP-Link T1500-28TC TL-SL2428 T1500-28TCUN V1 Installation Guide - Page 8

JetStream Smart Switch 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding 1000M LED. SFP Port Designed to install the SFP module. T1500-28PCT features some SFP transceiver slots that are shared with the associated RJ45 ports. The associated two ports are referred as a "Combo" port, which means they cannot be used simultaneously, otherwise only SFP port works. Meanwhile, the associated two ports share the same LED. For T1500-28PCT, Port 27 shares the same LED with Port 27F and Port 28 shares the same LED with Port 28F. ■■ Rear Panel The rear panel of T1500-28TC is shown as the following figure. Figure 1-3 Rear Panel of T1500-28TC Kensington Security Slot 100-240V~ 50/60Hz 0.3A Grounding Terminal Power Socket The rear panel of T1500-28PCT is shown as the following figure. Figure 1-4 Rear Panel of T1500-28PCT Kensington Security Slot 100-240V~ 50/60Hz 3.0A Power Socket Grounding Terminal Kensington Security Slot Secure the lock (not provided) into the security slot to prevent the device from being stolen. Power Socket Connect the female connector of the power cord here, and the male connector to the AC (Alternating Current) power outlet. Please make sure the voltage of the power supply meets the requirement of the input voltage. Grounding Terminal The switch already comes with lightning protection mechanism. You can also ground the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed information, please refer to Chapter 3 Lightning Protection. Caution: Please use the provided power cord. 05 Introduction