TP-Link TD-8610 User Guide
TP-Link TD-8610 Manual
 |
View all TP-Link TD-8610 manuals
Add to My Manuals
Save this manual to your list of manuals |
TP-Link TD-8610 manual content summary:
- TP-Link TD-8610 | User Guide - Page 1
TD-8610/TD-8610B External ADSL2+ MODEM Rev: 1.0.2 1910010011 - TP-Link TD-8610 | User Guide - Page 2
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced - TP-Link TD-8610 | User Guide - Page 3
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the - TP-Link TD-8610 | User Guide - Page 4
: ¾ One TD-8610/TD-8610B External ADSL2+ MODEM ¾ One AC power Adapter for TD-8610/TD-8610B External ADSL2+ MODEM ¾ One RJ45 cable ¾ Two RJ11 cable ¾ One ADSL splitter (only available for TD-8610) ¾ One Resource CD for TD-8610/TD-8610B External ADSL2+ MODEM, including: • This User Guide • Other - TP-Link TD-8610 | User Guide - Page 5
1.7 Electric parameter 2 Chapter 2. Hardware Installation Guide 3 2.1 System requirement 3 2.2 LED explanation 3 2.3 Rear-panel...4 2.4 Hardware installation procedures 4 Chapter 3. How to use 6 3.1 Computer Configuration 6 3.2 Login...7 3.3 Setup ...8 3.4 Software Dial 9 Appendix A: Default - TP-Link TD-8610 | User Guide - Page 6
connected to any 10M/100M Ethernet devices, support Auto-MDIX. TD-8610/TD-8610B not only use html (web mode through Ethernet port) to configure the MODEM but also use external utility software too. You can download it from our website (http://www.tp-link.com). 1.1 Product main specification ¾ High - TP-Link TD-8610 | User Guide - Page 7
data-rate: 1Mbps ¾ Max line length: 6Km TD-8610/8610B External ADSL MODEM 1.4 ATM property ¾ AAL0, AAL5, OAM, RM, and raw cell types supported ¾ Direct hardware support for 4 Receive VCs, with additional RX VCs and TX VCs supported in software ¾ Full 24-bit Virtual Path Identifier (VPI) and - TP-Link TD-8610 | User Guide - Page 8
TD-8610/8610B External ADSL MODEM Chapter 2. Hardware Installation Guide 2.1 System requirement Confirm your computer has been installed with networking interface card (NIC) before connecting ADSL MODEM to your computer, with operating system supporting the TCP/IP protocol. 2.2 LED explanation The - TP-Link TD-8610 | User Guide - Page 9
the LINE port of the TD-8610/TD-8610B ADSL2+ MODEM by telephone line. While you need to use a telephone, please attach telephone line into the phone of Splitter. Second Step: Connect category 5 cable with RJ45 jacks to ADSL MODEM's LAN port and your computer's NIC. Third Step: Link power adapter - TP-Link TD-8610 | User Guide - Page 10
TD-8610/8610B External ADSL MODEM Figure 2-1 5 - TP-Link TD-8610 | User Guide - Page 11
Chapter 3. How to use TD-8610/8610B External ADSL MODEM 3.1 Computer Configuration 1. Connect the cable according to Chapter 2, and then turn on the power. 2. Change the IP address of your PC（Figure 3-1）: Open TCP/IP Properties of the LAN card in your PC, enter the IP address as 192.168.1.* (* is - TP-Link TD-8610 | User Guide - Page 12
TD-8610/8610B External ADSL MODEM Choose Properties -> Right-click Local Connection -> Choose Properties -> Double-press Internet Protocol (TCP/IP). 3) The words in fact maybe are different with this guide. You can check whether your configuration is successful through PING command. Enter Ping 192. - TP-Link TD-8610 | User Guide - Page 13
TD-8610/8610B External ADSL MODEM Figure 3-4 The default user name and its password is admin; if you want to change it, please go to "Management→Password". (Figure 3-5) Figure 3-5 3.3 Setup 1) Choose ATM PVCs Configuration (See Figure 3-6) 2) Enter the VPI/VCI value which is provided by your ISP, - TP-Link TD-8610 | User Guide - Page 14
TD-8610/8610B External ADSL MODEM Figure 3-6 3.4 Software Dial TD-8610/TD-8610B works in bridged (RFC 1483 Bridged) mode to connect to the Internet. You need to install dial software on your PC. There is some software working on WINDOWS in market, example for EnterNet3000, RASPPPoE and WinPeET. 9 - TP-Link TD-8610 | User Guide - Page 15
TD-8610/8610B External ADSL MODEM Appendix A: Default Configuration USER NAME PASSWORD IP ADDRESS VPI/VCI admin admin 192.168.1.1 0/32,1/33,0/35,0/100,0/200,8/35,8/81 10
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
 |
 |
TD-8610/TD-8610B
External ADSL2+ MODEM
Rev: 1.0.2
1910010011