Tecumseh Products LEV90 Operator Manual - Page 18
Oil Fill Cap/Plug
View all Tecumseh Products LEV90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
II. Oil Fill Cap/Plug If your engine does NOT have an oil fill cap/dipstick go to step 1. If your engine has an oil fill cap/dipstick, see "I. Oil Fill Cap/Dipstick" instructions on page 14. 1. Carefully disconnect spark plug wire and keep it away from spark plug. See Figures 38 and 39. See "G" Avoid Accidental Starts" instructions on page 2. Afterward, continue reading instructions below. • Keep the disconnected spark plug wire securely away from metal parts where arcing could occur. • Carefully attach the spark plug wire to the grounding post, if provided. Figure 38. Disconnecting/Connecting Spark Plug 1 2 2. Be sure fuel fill cap is on and tightened securely. See Figure 40. 3. Be sure you find the correct oil drain plug location (see equipment manufacturer's instructions). See Figure 41. 1. Grounding Post Connection 2. Spark Plug Connection Figure 39. Typical Grounding Post/Spark Plug Connection 4. Clean area around oil drain plug. 5. Place approved recyclable oil container under oil drain plug, tipping engine to position the oil drain plug at the lowest point on the engine (see equipment manufacturer's instructions). 6. Remove oil drain plug and drain oil into an approved recyclable oil container. Figure 40. Fuel Fill Cap NOTE Used oil must be disposed of at a proper collection center. 7. Install oil drain plug and tighten securely. Page 16 Figure 41. Oil Drain Plug Locations Four-Cycle Engine • Vertical Crankshaft • Air-Cooled 181-1215-14