Tecumseh Products LV148EA Operator Manual - Page 15
VI. Stopping Your Engine and, Short-Term Storage, VII. Maintenance - oil change
View all Tecumseh Products LV148EA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
VI. Stopping Your Engine and Short-Term Storage Stop engine according to equipment manufacturer's instructions. WWAARRNNININGG To avoid unsupervised operation of an engine, especially by children, NEVER leave it unattended when it is running. Always turn off the engine after use and remove ignition key, if provided. Failure to do so may lead to serious injury or death. WWAARRNNININGG NEVER store engine with fuel in the fuel tank inside a building with potential sources of ignition such as hot water or space heaters, clothes dryers, electric motors, etc. Doing so may lead to an explosion resulting in death or serious injury. VII. Maintenance WWAARRNNININGG To avoid serious injury or death, an adult should perform maintenance on this engine. Only allow children to perform maintenance if an adult has determined they are experienced and capable of such operation. WWAARRNNININGG To prevent accidental starting when working on equipment, always: • Carefully disconnect spark plug wire and keep it away from spark plug. See Figures 28 and 29. • Keep the disconnected spark plug wire securely away from metal parts where arcing could occur. • Carefully attach the spark plug wire to the grounding post, if provided. • Disconnect battery at negative terminal first, if engine is equipped with a DC electric starter. • Turn all engine switches to "OFF" position. • Remove ignition key, if provided. Figure 28. Disconnecting/Connecting Spark Plug 1 2 1. Grounding Post Connection 2. Spark Plug Connection Figure 29. Typical Grounding Post/Spark Plug Connection A. Checking and Changing Oil To avoid engine damage, it is important to: • Check oil level before each use and every 5 operating hours when engine is warm. See "A. Checking Oil Level" instructions on page 4. Afterward, continue reading instructions below. • Change oil after first 2 operating hours and every 25 operating hours thereafter; more often if operated in extremely dusty or dirty conditions. Engine should still be warm but NOT hot from recent use. NOTES For engines with a dipstick, see "I. Oil Fill Cap/Dipstick" instructions on page 14. For engines without a dipstick, see "II. Oil Fill Cap/Plug" instructions on page 16. 181-1215-14 Four-Cycle Engine • Vertical Crankshaft • Air-Cooled Page 13