Toshiba 27A50 Owners Manual - Page 30
Using V-Chip Control, To return to the normal picture, Factory reset status, Example
View all Toshiba 27A50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Using V-CHIP Control Set up Some TV programs and movies include signals that classify the content of the program (violence, sex, dialog, language). The V-CHIP Control feature in this TV detects the signals and blocks the programs according to your selections. To use this feature, perform the following setup. Preparation Reference Section Advanced Operation Basic Operation RECALL RECALL MUTE o POWER 1 23 4 56 7 89 CH RTN 100 0 ENT T/ S MENU CH VOL MENU/ VOL ENTER TV CABLE VCR CH EXIT FAV CH TV/VIDEO A REC TV/VCR STOP PLAY STILL SOURCE PIP SLOW PAUSE REW FF PIP CH LOCATE SWAP Selecting the V-CHIP CONTROL menu 1 Press MENU then s or t repeatedly until "V-CHIP CONTROL" in the Set up menu is displayed in purple. Number buttons 2 Press T or S to display the pin code entering mode. G Factory reset status Set your 4 digit code by pressing the Number buttons (0-9). s/ t Example: To enter "1110" Press 1, 1, 1, and 0 in order. EXIT G When the pin code is already stored Press the Number buttons (0-9) to enter the 4-digit pin code used to block channels. TIMER: 0 MIN TV/CABLE: [TV]CABLE CH PROGRAM ADD/ERASE: [ADD]ERASE V-CHIP CONTROL FAVORITE CH MOVE[t s] START[T S] BLOCKING IS RESET PLEASE ENTER NEW PIN CODE 1110 SELECT[0-9] END[EXIT] BLOCKING IS ACTIVE PLEASE ENTER PIN CODE 1234 SELECT[0-9] END[EXIT] To return to the normal picture Press EXIT. If a wrong pin code has been entered this message will appear. Try to enter the correct code again. If you can not remember the pin code you have stored, while in the pin code entering mode, press the RECALL button four times within 5 seconds. The pin code you have stored will be released. (Factory reset status). 3 After about 1 second, the screen changes to the V-CHIP CONTROL menu as shown. INCORRECT PIN CODE PLEASE ENTER PIN CODE 1235 SELECT[0-9] END[EXIT] ENABLE BLOCKING : Y[N] SET RATING SET BLOCKING OPTIONS NEW PIN CODE BLOCK CHANNEL MOVE[t s ] SELECT[T S ] Continue to set each item following the steps on the next page. 30