Toshiba 62HM94 Owner's Manual - English - Page 25
G-LINK, connection
UPC - 022265262191
View all Toshiba 62HM94 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2: Connecting your TV G-LINK™ connection This connection is necessary for the TV Guide On Screen™ system to work with your cable box to receive program listings and to enable TV Guide On Screen recording features with your VCR. Note: This connection is not necessary for AVHD or D-VHS recording devices. See pages 23 and 49 for further details. After you connect your devices to the TV, you will need to connect the G-LINK cable (either of the dual-wand IR blaster cables included with your TV) from your VCR and Cable box (if applicable) to the G-LINK jack on the TV. Note: TV Guide On Screen program data is available through the ANT-1 and ANT-2 antenna inputs and also through the VIDEO 1 inputs if you have a cable box connected to VIDEO 1. TV Guide On Screen program data is not available through any other inputs on this TV. See the connection information on pages 13-25. The G-LINK connection is necessary to enable the following features of your TV Guide On Screen™ system: • If you have a Cable box, you need to connect the G-LINK cable from the Cable box to the G-LINK jack to receive the TV Guide On Screen system's program listings for your Cable service. • If you have a VCR, you need to connect the G-LINK cable from the VCR to the G-LINK jack to use the TV Guide On Screen system's recording features. To connect to the G-LINK jack: 1. Locate the infrared sensor on the front of your VCR or Cable box. The sensor is marked on some devices.* 2. Align one of the G-LINK (IR blaster) cable's wands about 1 inch away from the infrared sensor on the front of the VCR and attach it using double-sided mounting tape. If you have a Cable box, attach the other wand in a similar manner. (See illustration at right.) Note: If you do not have a Cable box, coil the second wand with a rubber band and leave it behind the TV. Front of Cable box Front of VCR Infrared sensor 3. Plug the G-LINK (IR blaster) cable's plug into the TV's G-LINK jack. For details on setting up the TV Guide On Screen system: See Chapter 5. For details on using the TV Guide On Screen interactive program guide: See Chapter 7. *If you cannot locate the device's infrared sensor: 1. Turn OFF the device. 2. Starting at the lower left corner of the device, place the end of the device's remote control (with the infrared emitter) so it touches the front of the device and press POWER. (Do not use the TV's remote control for this step.) 3. If the device turns on, the place the remote control touched the device is the location of the sensor. 4. If the device does not turn on, move the remote control slightly to the right and press POWER again. 5. Repeat step 4 until you locate the device's infrared sensor. G-LINK (IR blaster) cable wand (approx. 1 inch from device) Back of TV IN AUDIO ANT1 (CABLE) TheaterNet IEEE1394 1 CableCARD™ EJECT 2 HDMI IN OUT 1 S-VIDEO S-VIDEO Y R L Y OUT 2 TheaterNet VIDEO L/ MONO PB VIDEO PR L/ MONO L PB VIDEO PR L/ L MONO AUDIO R VIDEO 1 AUDIO AUDIO AUDIO RR R COLOR COLOR VIDEO 2 STREAM STREAM HD-1 IN HD-2 AUDIO R VAR AUDIO L R OUT ANT2 ANT (75 ) G-LINK DIGITAL AUDIO OUT HM94(E)012-25(2B-Cnct) 25 Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. 8/31/04, 12:53 PM 25