Toshiba SD-P1700SN User Manual - Page 57

Connecting to Headphones You can listen to movies and music privately by connecting headphones. Headphones (not supplied) To (headphone) jack Connect either of these jacks. To use 2 pairs of headphones at the same time, use commercially-available headphones for the other jack. CAUTION When you use headphones, keep the volume at a moderate level. If you use the headphones continuously with high volume sound, it may cause hearing damage. Connecting headphones Connect headphones to the headphone jack using a stereo mini plug. Before connecting, temporarily turn down the volume with the headphone volume control. Readjust to your preference when playback starts. • Turn off the player before you connect or disconnect the headphone cable. Possible shakes produced by plug connecting/disconnecting may cause damage to the disc. • You can connect up to 2 headphones. Connections Connecting to Audio Equipment You can enjoy high quality dynamic sounds by connecting the player to audio equipment. • For connection to your TV, see "Connecting to a TV" 54 . • For details of output sound, see 40 . • This section uses the following reference marks. : Front speaker : Rear speaker : Sub woofer : Center speaker : Signal flow CAUTION • When you are connecting (via the BITSTREAM/PCM jack) an AV decoder that does not have Dolby Digital, Digital Theater Systems (DTS) or MPEG2 decoding function, be sure to set "Digital Out" to "PCM" from the on-screen displays 46 50 . Otherwise, high volume sound may damage your hearing as well as the speakers. • When playing DTS-encoded discs (audio CDs), excessive noise may be output from the analog audio output jacks. To avoid possible damage to the audio system, you should take proper precautions when the analog audio output jacks of the player are connected to an amplification system. To enjoy DTS Digital Surround® playback, an external 5.1 channel DTS Digital Surround® decoder system must be connected to the BITSTREAM/PCM jack of the player. Notes • DO NOT connect the BITSTREAM/PCM jack of the player to the AC-3 RF input of a Dolby Digital Receiver. This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the BITSTREAM/PCM jack of the player. • Connect the BITSTREAM/PCM jack of the player to the "DIGITAL (OPTICAL)" input of a Receiver or Processor. • Refer to the owner's manual of the connected equipment as well. • When you connect the player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections. • The output sound of the player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound. • Turn off the amplifier before you connect or disconnect the player's power cord. If you leave the amplifier power on, the speakers may be damaged. 57