Toshiba TLP-X100U User Manual - Page 12

Connection Before connection • Read the owner's manual of the device you are connecting to the projector. • Some computers cannot be used with or connected to this projector. Check for an RGB output terminal, supported signal p.53 , etc. • Turn off the power of both devices before connecting. • The figure below shows sample connections. This does not mean that all of these devices can or must be connected simultaneously. (Dotted lines mean items can be exchanged.) Video recorder, DVD player, etc. Computer DVD video recorder, etc. To audio output White (L)/ Red (R) To video output To S-video S-video cable output (not supplied) To RGB output Video cable (not supplied) RGB cable (supplied) Audio cable (not supplied) Audio cable (not supplied) Conversion adapter BNC-pin (not supplied) To Y/CB/CR output Green(Y)/Blue(CB)/ Red (CR) To audio ouput Monitor cable Mini D-sub 15P-BNC (not supplied) Audio cable (not supplied) To audio ouput White (L)/ Red (R) Notes • When COMPUTER 2 IN terminal is used as MONITOR OUT terminal, the signal which is input to COMPUTER 1 IN terminal is output. • Signals are output from MONITOR OUT terminal even in standby mode. However, from AUDIO OUT terminal, no audio signal is output. • A computer monitor cannot accept Y/PB/PR signals correctly. • The AUDIO IN terminal can be used for devices connected to COMPUTER 1 terminal, COMPUTER 2 terminal, VIDEO terminal and S-VIDEO terminal. • When an AUDIO OUT terminal is connected, sound is not output from the projector speaker. • Output volume of AUDIO OUT terminal can be adjusted by the VOL button. Preparations Audio cable (not supplied) Control cable (not supplied) To audio intput White (L)/Red ( R) To RS-232C terminal p.55 Monitor Audio amplifier, etc. Computer (for control) It is necessary to switch to MONITOR OUT by the switch. p.18 * The connection for COMPUTER 1 IN terminal described here is also applicable for COMPUTER 2 IN terminal. 22 23