Toshiba XM-7002B Product Specification

Toshiba XM-7002B - CD-ROM Drive - IDE Manual

Get Toshiba XM-7002B - CD-ROM Drive - IDE PDF manuals and user guides View all Toshiba XM-7002B manuals
Add to My Manuals
Save this manual to your list of manuals

Toshiba XM-7002B manual content summary:

  • Toshiba XM-7002B | Product Specification - Page 1
    TOSHIBA DISK PRODUCTS DIVISION XM-7002B CD-ROM DRIVE PRODUCT SPECIFICATION JUNE 1999 Rev. 1.0 Specifications are subject to change without notice DOCUMENT NUMBER 12095
  • Toshiba XM-7002B | Product Specification - Page 2
    Toshiba because of same troubles, etc., turn off instruction manual of your product, statement described in "Safety Instruction Manual "attached to this product, the statement of item 2 and 8 above, and other required statements should be mentioned for thorough understanding by the users. XM-7002B
  • Toshiba XM-7002B | Product Specification - Page 3
    Drive Life 10 3.5.5. Mechamical Life 10 4. Configuration 10 4.1. Electrical Parts 10 4.2. Optical Pickup 10 4.3. Spindle Motor 10 4.4. Feed Motor 10 5. Functions 12 5.1. CD-ROM 19 6.4.1.ATAPI Packet Command for CD-ROM Device 19 6.4.2.ATA Commandfor ATAPI CD-ROM Device 20 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 4
    . Emergency Eject 24 13. Safety Standards/Agency Approvals 24 14. Electrostatic Discharge 25 15. Accessories 25 16. Packaging 25 17. CE Declaration of conformity 25 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 5
    drive offer long life and high durability because the disc is read by a LASER, thereby eliminating physical contact with the disc. This drive support ATAPI (ATA Packet interface) Revision 2.6 spec. and SFF8090 Version 2 (Mt. Fuji Commands for CD and DVD-Devices) of CD/DVD Command. 1/27 XM-7002B
  • Toshiba XM-7002B | Product Specification - Page 6
    PC98 Spec. (11) Supprt ACPI Spec. (12) Drawer Type Manual Load /Electrical Release (13) Emergency Eject (14) Built-in ATAPI Interface Controller (15) Support < CD-DA Transfer Over ATAPI >Function (16) Sub code P Thru W Transfer over ATAPI Bus (17) Built-in MODE-1 ECC/EDC (18) Embedded CD-ROM XA
  • Toshiba XM-7002B | Product Specification - Page 7
    User Data/Block Red-Book, Yellow-Book, CD-ROM XA, CD-IBridge ( Photo-CD, Video CD ), CD-I, CD-I Ready, CD-G and Multisession ( Photo-CD,CD EXTRA ), CD-RW, CD-R, CD-TEXT 2,048 Byte/block(Mode 1) 2,336 Mode 4) 16.7 MByte/s (DMA multi word Mode2) 33.3 MByte/s (ULTRA DMA Mode2) 3/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 8
    (10X) Average Full Stroke Access Time*5 180 ms (Max.24X) 200 ms (10X) *1: All CD formats, except CD Red book (audio), require additional application specific software and/or hardware. The CD-ROM drive referenced in the specification is capable of reading these data formats. However, in order to
  • Toshiba XM-7002B | Product Specification - Page 9
  • Toshiba XM-7002B | Product Specification - Page 10
  • Toshiba XM-7002B | Product Specification - Page 11
  • Toshiba XM-7002B | Product Specification - Page 12
    3. There will be possibility that the drive does not detect the vibration. It depends on mounting condition. M2 Screws CD-ROM Drive M2 Screws M2 Screws Toshiba DynaBook Satellite Pro 440 series PC Adapter Bulk Packaged on one pallet) 135 kg (24 Bulk Packaged on one pallet) 8/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 13
    Figure 4 External Dimensions 9/27 (Unit:mm) XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 14
    (2) Optical Pickup Servo Control Circuit (3) Feed Motor Drive Circuit (4) Laser Diode Control Circuit (5) EFM Demodulator and CD-ROM Error Correction Circuit (6) IDE/ATAPI Interface Control Circuit Motor 4.4. Feed Motor DC Motor with Non-contact Type Velocity sensor 10/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 15
    Figure 5 Basic configuration of XM-7002B 11/27 XM-7002B BLOCK DIAGRAM D ISC MOTOR PUH MO DRIVER EJECT SW FEED MOTOR POSITION SERVO CONTROL MASTER CLOCK GEN. 33.86 MHz D-RAM 128 kB CD-ROM DATA SYNC DETECT CONTROL DE-SCRAMBLE HEADER DETECT ERROR CORRECTION IDE/ATAPI INTERFACE
  • Toshiba XM-7002B | Product Specification - Page 16
    -1) 288 bytes ~ ~ 4 bytes Minutes Second(0~59) Blocks(0~74) Mode ~ ~ Figure 6 CD-ROM Data Configuration 5.2. Power ON/OFF Timing Figure 7 shows the initialization. Power ON System Initialization Focus -Command"Acceptable "Good"Status Figure 7 Initialization Sequence 12/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 17
    SPEC, ATAPI-SPEC SFF-8020i Revision 2.6, SFF-8028 Revision 1.0 and SFF-8090 version 2. (Small Form Factor Committee Specification of ATA-Packet Interface for CD-ROMs ended TTL compatible receivers and drivers communicating through a 50P-conductor as shown in Figure 9,10 - 13. 13/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 18
    Rx Ri Rs CSEL /RESET /DMACK Rx Rs timing control VOH Voltage Output High VOL Voltage Output Low IOL Driver sink current ILO Output Leakage Current Vdd-0.4 V 0.4 V 12 mA -10 µA 10 µA IOH=400 µA IOL -5 µA -150 µA Pullup Resistor(Ri) 8 pF Figure 9 Signal Specifications 14/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 19
    10 Host Interface Timin Min Time (ns) Max Time (ns) 120 25 70 25 20 10 20 5 30 30 30 10 0 35 1250 15/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 20
    DIOR- to DMREQ delay tLw DIOR- to DMREQ delay Figure 11 Host Interface Timing (DMA Multi) Max time (ns) --- 50 25 35 35 16/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 21
    time tACK Setup and Hold Time for DMACK- tENV Envelope time t2AD Minimum Delay time for Driver t2IORODY Minimum time for DMACK- tFS First STROBE time tRFS Ready-to-Final STROBE time tRP Figure 12 Host Interface Timing (Ultra DMA) Max time (ns) 70 170 50 150 17/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 22
    Electronics Industry Limited KX14-50K*D or equivalent. (Note: * is No.2.85,5, 8, 11. The recommendation is No.5) CD-ROM DRIVE REAR VIEW TOP 11 1 3 5 7 9 13 15 17 19 21 23 25 27 29 31 33 35 37 anything with vender unique (50P). Figure 14 Signal assignments 18/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 23
    Support Command List 6.4.1. ATAPI Packet Command for CD-ROM DVD CAPACITY READ CD READ CD MSF READ DISC INFORMATION COMMAND READ FORMATTED CAPACITIES COMMAND READ HEADER READ SUB-CHANNEL READ TOC READ TRACK/RZONE INFORMATION COMMAND REQUEST SENSE REZERO UNIT SEEK SET CD-ROM 1Bh 00h XM-7002B YES YES
  • Toshiba XM-7002B | Product Specification - Page 24
    ATA Command for ATAPI CD-ROM Devices Command ATAPI SOFT RESET CHECK POWER MODE EXECUTE DRIVE DIAGNOSTICS IDLE IMMEDIATE IDLE NOP ATAPI PACKET COMMAND ATAPI IDENTIFY DEVICE SET FEATURES SLEEP STANDBY IMMEDIATE STANDBY OP Code 08h E5h 90h E1h E3h 00h A0h A1h EFh E6h E0h E2h XM-7002B YES YES YES YES
  • Toshiba XM-7002B | Product Specification - Page 25
    LPF) (7) Signal to Noise Ratio 78 dB Typ (IEC 179 A-weighted) 8.1.1. Audio Cable (1) Capacitance (2) Length Unbalanced and shielded Less than 1000 pF Max. 3 m 21/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 26
    -circuit the PIN 47 and PIN 48 of I/O connectors. *Master mode can be oppositely to Slave mode according to the specification. (CSEL mode) 22/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 27
    CD-Audio playback (3) When performing 'Data Access' and during 'Data Transfer' Busy Indicator keeps turn On. Light On Figurer 19 Data Access and Data Transfer (4) When pushing Eject button, Busy indicator is blinking at 0.4 s intervals. 0.4 s Light Off at the Eject Figurer 20 Eject 23/27 XM-7002B
  • Toshiba XM-7002B | Product Specification - Page 28
    case of emergency (drawer will not eject although pressing Eject button). (1) Turn the CD-ROM drive supplying power off, and then keep the this condition for 1 minute. (2) Insert MHz, 1 kHz 80 % AM] IEC61000-4-8 : 1993 [1 A/m, 50 Hz] (5) EMI KOREAN EMI Regulation (RRL) 24/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 29
    Pack 24 Bulk Packs on one Pallet Packing Specifications :for 25 Packaged Model: IB-CD2-A90012 :for 20 Packaged Model: IB-CD2-A90013 25/27 XM-7002B Rev.1.0
  • Toshiba XM-7002B | Product Specification - Page 30
    EUROPE GMBH EU-Declaration of Conformity Product: CD-ROM Drive Manufacturer(s): Toshiba Corporation 1-1, Shibaura 1-chome, Minato-ku, Tokyo 105-8001 Japan See page 2 for other locations Model: XM-7002B Options: None Toshiba declares that the above mentioned product(s) with or without
  • Toshiba XM-7002B | Product Specification - Page 31
    5 kHz, Polarity: +/3 V, 0.15-80 MHz, 80 % AM 1 A/m, 50 Hz 27/27 Product/Options CD-ROM Drive Model XM-7002B Related EU-Directive 89/336/EEC X Manufactuer(s) Location Toshiba Multi Media Devices Co, L Toshiba Misawa Media Devices Co, Lt EMS Corp. Hokuto Communication Industrial Co., Ltd. Yuzawa
  • Toshiba XM-7002B | Product Specification - Page 32
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
DISK PRODUCTS DIVISION
TOSHIBA
XM-7002B
CD-ROM DRIVE
PRODUCT SPECIFICATION
JUNE 1999
Rev. 1.0
Specifications are subject to change without notice
DOCUMENT NUMBER
12095