Tripp Lite 5P850G Eaton 5P UPS Installation and User Manual - Page 11
LCD description
View all Tripp Lite 5P850G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH 2.5 LCD description Operation status 2. Presentation Load/equipment status Normal mode 100% 720W 800VA 100% 10min Efficiency: ~98% Battery status Efficiency and load group information As default, or after 5 minutes of inactivity, the LCD displays the screen saver. The backlight LCD automatically dims after 10 minutes of inactivity. Press any button to restore the screen. The following table describes the status information provided by the UPS Note: If other indicator appears, see troubleshooting on page 18 for additional information. Operation status Standby mode Possible cause Action The UPS is OFF, waiting for start-up Equipment is not powered until command from user button is pressed. Normal mode The UPS is operating normally. The UPS is powering and protecting the equipment. In AVR mode No beep On Battery Battery LED is on 1 beep every 10 seconds End of backup time 1 beep every 3 seconds The UPS is operating normally but the utility voltage is outside normal mode thresholds. The UPS is powering the equipment through a Automatic Voltage Regulation device. The equipment is still normally protected. A utility failure has occurred and the UPS is in Battery mode. The UPS is powering the equipment with the battery power. Prepare your equipment for shutdown. The UPS is in battery mode and the battery is running low. This warning is approximate, and the actual time to shutdown may vary significantly. Depending on the UPS Load, the "Battery Low" warning may occur before the battery reaches 20 % capacity. 620-00082-01-us (en) Page 11