Troy-Bilt Flurry 1400 Operation Manual - Page 7
Assembly & Set-Up - electric snow thrower
View all Troy-Bilt Flurry 1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Assembly & Set-Up 3 Contents of Carton • One Electric Snow Thrower • One Chute Assembly • One Upper Handle • One Electric Snow Thrower Operator's Manual • One Mid Handle • One Product Registration Card NOTE: All references to the left and right side of the snow thrower are from the operator's position behind the snow thrower. Tools Required for Assembly • Phillips Head Screwdriver Unpacking the Unit 1. Cut the corners of the carton and lay the sides flat on the ground. Remove all packing inserts. 2. Lift the upper handle and mid handle up and off the snow thrower. See Fig. 3-1. Handle Assembly 1. Install the strain reliever on the mid handle. See Fig. 3-2. Figure 3-2 NOTE: The flared area on the lower portion of the mid handle must face forward throughout the assembly. 2. Attach the upper handle to the mid handle using one carriage screw and handle knob on each side. See Fig. 3-3. Figure 3-1 3. Make certain the carton has been completely emptied before discarding it. Carriage Bolt Carriage Bolt Handle Knobs Figure 3-3 NOTE: Make sure the cord is routed behind the handle assembly. 7