Uniden EXAI8580 English Owners Manual - Page 3
Connect the Telephone Cord - handset
UPC - 050633280416
View all Uniden EXAI8580 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
7 Place the handset in the base. What if the charge LED doesn't light up? • Check AC adapter connection. • Make sure you are not using an outlet that's controlled by a wall switch. Make sure that the charge/in use LED illuminates. Note: For optimum battery life, charge your handset completely before you connect the telephone cord. The first time you charge a new battery, allow 15 to 20 hours. 1-4. Connect the Telephone Cord 8 Connect the telephone cord to the TEL LINE jack on the rear of the base. 9 Route the cord through the hole in the stand and into the molded wiring channel. To TEL LINE To telephone wall jack 10 Connect the telephone cord to a telephone wall jack. Telephone cord (supplied) Note: If the telephone cord does not fit into your telephone wall jack, contact your local phone provider for assistance. If you receive high-speed internet service through your telephone line (referred to as DSL), you should install a DSL filter between the telephone base and the wall jack. Standard telephones often can't operate correctly without a DSL filter. Telephone cord DSL filter Telephone wall jack Testing the connection 11 Pick up the handset from the base and press [TALK/flash]. You should hear a dial tone, and the display should show TALK. Talk 0:01 What if I can't hear a dial tone? Check the telephone cord connection on the base. What if the display doesn't show TALK? Put the handset back in the base for at least five seconds. Make sure the charge/in use LED flashes. 12 Make a quick test call, and then press [END] to hang up. What if the call doesn't go through? Try changing the dial mode (see below). What if there is a lot of static? Check the sources of interference described in section 1-1 on Choosing the best location: is the base near any of those? Changing from tone to pulse dialing (DIAL) Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If your phone company uses pulse dialing, you need to change your phone's dial settings. If you don't get a dial tone or can't connect to the telephone network, follow the steps below to modify your phone's settings: 1) With the phone in standby, press and hold [cid/menu]. 2) Press [ ] to move the pointer to DIAL. 3) Press [select/channel] to set the phone to pulse dialing. 4) Press [END] and put the handset back in the base. The handset communicates the new setting to the base. Note: If you use pulse dialing and you need to send DTMF tones during a call (if you're using an automated response system, for example), press [ /tone/ ] to temporarily switch to tone dialing. When the call ends, the phone automatically returns to pulse dialing mode. Now your phone is ready to use!