ViewSonic PJD6210-3D User Guide - Page 27

1. Turn off the projector. 2. Unplug the power cord. „ If the projector is installed in a ceiling 3 mount, remove it from the mount. 4 Place a protective sheet (cloth) 5 beneath the projector. Turn the projector over so you can access the lamp cover. 3. Loosen the screw in the lamp cover and remove the cover. 4. Loosen the two screws from the lamp module. 5. Pull up the handle, and then pull out the lamp unit by the handle. 6. Insert a new lamp module into the projector and tighten the screws. 7. Replace the lamp cover and tighten the screw. 8. Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp. 9. Reset the lamp hour. Refer to the Setting (Computer / Video Mode) menu. „ Dispose the used lamp according to local regulations. „ Ensure that screws are tightened properly. Screws not tightened fully may result in injury or accidents. „ Since the lamp is made of glass, do not drop the unit and do not scratch the glass. „ Do not reuse the old lamp. This could cause the lamp to explode. „ Be sure to turn off the projector and unplug the AC power cord before replacing the lamp. „ Do not use the projector with the lamp cover removed. ViewSonic 24 PJD6210/PJD6210-WH