Viking DTWN3048SS Installation Instructions - Page 24

3 4 2 Place duct cover top inside duct cover base and lower until desired height is found. Mark height. Use the retaining nuts and bolts to fasten in place from inside and remove tape. Slide duct cover in place and fasten from inside canopy using the sheet metal screws provided. Duct Cover Option (DTWN Tall Traditional Wall Hoods) 1 2 2 Measure distance from ceiling to canopy. Installation (DTWS Slim Traditional) Slide duct cover in place and fasten from inside canopy using the sheet metal screws provided. 1 WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING • Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. • Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Flip hood over. Remove electrical box cover. 46 2 3 2 1 5/16" nut driver Insert 6" of electrical wiring through the top of vent hood and secure using wiring restrain. Refer to local codes. CAUTION: Using screws provided, secure vent hood to wall. Make sure mounting screws are secured into frame. Use additional mounting screws and wall anchors, if necessary. 4 BARE OR GREEN 5/16" nut driver CAUTION: If not using a duct cover, use screws provided and make sure top mounting screws are secured into soffit or cabinet frame. Use additional mounting screws, if necessary. 5 1 1 2 WHITE WHITE GREEN BLACK BLACK Connect black to black, white to white, and the green/bare wire under the green screw. NOTE: Housing wiring must be properly installed for wiring to be correct when wiring unit. To install ventillation kit refer to ventillation kit installation instructions. Replace electrical box cover. Make connection to breaker box. 47