Viking VCBB5363E Use and Care Manual - Page 14
Caution, Warning
View all Viking VCBB5363E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Cleaning & Maintenance Glass Shelves To clean your refrigerator's glass shelves, lift the shelf out by lifting the front and releasing the hooks from the metal track. Then pull the shelf out. Be sure to allow the glass shelves to adjust to room temperature before cleaning. To clean crevices, dilute mild detergent with water. Brush this solution into crevices using a plastic bristle brush. Let set for five minutes. Spray warm water into crevices using faucet spray attachment. Dry glass shelf thoroughly and replace shelf by inserting hooks into metal track and lowering front. Door Gaskets Clean the door gaskets every three months using the same procedures used for interior surfaces. You should apply a light film of petroleum jelly to keep gaskets pliable. CAUTION To avoid personal injury or property damage, handle tempered glass shelves carefully. Shelves may break suddenly if nicked, scratched, or exposed to sudden temperature change. WARNING WARNING ELECTRICAL SHOCK HAZARD Disconnect power or turn power disconnect switch to OFF position before removing top grille. Failure to do so can result in death or electrical shock. BURN HAZARD DO NOT touch condenser coils near defrost pan. Doing so can result in burns. Defrost Pan To prevent condensation from overflowing, check defrost pan periodically. To check defrost pan, remove two screws securing kickplate to unit. Pull defrost pan forward until it stops. Remove any excess water from pan. Wipe and clean defrost pan with a sponge. Return defrost pan to original position. Return kickplate to unit by securing with two screws. Door Stop Adjustment Your refrigerator is factory set at the 110º door stop position. To change to either the 90° or 120° position, remove the door stop pin using a 3/16" (0.5 cm) allen wrench. Bottom-Freezer 1 2 120˚ 110˚ 90˚ 1 3 2 1 2 Product Care Open refrigerator door so door stop and shoulder screw are accessible. 14 Remove shoulder screw and place in 90º or 120º position.