Viking VCWH 1500 CFM Exterior-Power Ventilator Kit - Installation Instructions - Page 4
Viking Range, Install The Rough-in Plate, Use And Care
View all Viking VCWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INstall the rough-in plate 1. Run 10" round steel ductwork, from exterior ventilator to the installation location. For best performance, use the straightest possible duct run and the fewest number of elbows. Tape all joints. 2. Run 120 VAC electrical power cable from service panel and from remote ventilator to installation location. 3. Remove wiring box cover. Remove knockouts from the wiring box. Feed 6" of power cable through openings and attach cables to wiring box with appropriate connectors. BBrLAoCwKn b GREEN GREEN / YELLOW bBBlRuOeWN M bBlBaLcUkE bBBlLaUcEk GROUND WHITE BLACK CAPACITOR EXTERIOR BLOWER BLACK WHITE ROUGH-IN PLATE LEAD WIRING BOX GREEN WHITE BLACK LINE IN 120 VAC 60 HZ 10 A MAX. BLACK WHITE GREEN ROUGH-IN PLATE LEAD 4. Wire black to black, white to white, and green or bare wire beneath green ground screw. Replace wiring box cover. use and care Disconnect electrical power supply and lock out service panel before cleaning or servicing this unit. CLEANING Remove cover and carefully vacuum ventilator and inside of housing. Be careful not to bend or otherwise damage ventilator wheel. MOTOR LUBRICATION The motor is permanently lubricated. Do not oil or disassemble motor. 5. Connect ductwork to transition and tape joint. 6. Turn on power and check ventilator operation. VIKING RANGE00' gREENWOOD, mISSISSIPPI 38930 USA 99043942B F20257