Viking VISC5304BSS Installation Instructions - Page 7

Installation

Page 7 highlights

DANGER Installation CAUTION To avoid risk of personal injury or product damages, DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, or a qualified licensed plumber. Door Removal 1FOR YOUR SAFETY 2 FRONT REAHR OT FRONT REAHR OT FRONT REAHR OT FRONT REAHR OT Open door completely. Place pins, supplied with unit, in pin hole. For personal safety, ONLY use pins supplied with the unit. 3 FRONT REAHR OT FRONT REAHR OT Remove hinge trim screws. Take off hinge trim. Identify right and left hinge for future re-installation. 4 FRONT REAHR OT FRONT REAHR OT Close until pins stop door. 12 Lift door up and out. Leg Installation 1 FRONT REAHR OT FRONT REAHR OT Legs are packed in styrofoam top pack. Note: Legs should be installed near to where appliance is to be used, as they are not secure for long transit. 3 FRONT REAHR OT FRONT REAHR OT 2 FRONT REAHR OT FRONT REAHR OT 1 1 3 2 Note: It is strongly recommended that a pallet or lift jack be used rather than tilting. Raise unit about a foot. Unscrew temporary legs from couplings. 4 FRONT REAHR OT FRONT REAHR OT Screw legs into couplings on all four corners. Lower range gently to keep any undue strain from legs and internal mounting hardware. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

13
1
1
1
2
3
2
Legs are packed in styrofoam top pack.
Note:
Legs should be installed near to where
appliance is to be used, as they are
not secure for long transit.
Note:
It is strongly recommended
that a pallet or lift jack be used rather than tilting.
Raise unit about a foot.
Unscrew temporary legs from
couplings
.
4
Lower range gently to keep any undue strain from
legs and internal mounting hardware.
3
Screw legs into couplings on all
four corners.
Leg Installation
12
CAUTION
To avoid risk of personal injury or product
damages,
DO NOT
use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit.
DO NOT
lift or carry
the door by the handle.
Removing the door must be done by your
dealer, or a qualified licensed plumber
.
Door Removal
1
Open door completely. Place pins,
supplied with unit, in pin hole. For personal safety,
ONLY use pins supplied with the unit.
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
3
Close until pins stop door.
4
Lift door up and out.
Installation