Viking VWH2410SS Installation Instructions - Page 20
Installation, Duct Cover Option
View all Viking VWH2410SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
6 5/16" nut driver CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and wall anchors, if necessary. 7 BARE OR GREEN WHITE WHITE GREEN BLACK BLACK 5/16" nut driver CAUTION: If not using a duct cover, using screws provided, make sure top mounting screws are secured into soffit or cabinet framing. Use additional mounting screws, if necessary. 8 1 1 2 Connect black to black, white to white, and the green/bare wire under the green screw. NOTE: Housing wiring must be properly installed for wiring to be correct when wiring unit. 9 1 Replace electrical box cover. Make connection to breaker box. 10 1 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 2 3 Slide spacer front over front lip. Push spacer rear up, then slide back over rear lip. 38 11 1 2 3 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. Duct Cover Option (VWH 10"H. Wall Hoods w/Standard Ventilator) 1 2 2 Measure distance from ceiling to canopy. Slide the duct cover in place and fasten from inside canopy using the sheet metal screws provided. Installation (VWH 10"H. Wall Hoods w/Recirculating Kit) 1 2 Remove damper and discard with transition. Turn recirculating unit upside down. Place vent hood upside down on recirculating unit. 39