Viper Responder One Owner Manual

Viper Responder One Manual

Get Viper Responder One PDF manuals and user guides View all Viper Responder One manuals
Add to My Manuals
Save this manual to your list of manuals

Viper Responder One manual content summary:

  • Viper Responder One | Owner Manual - Page 1
    Responder One Remote Start Owner's Guide © 2008 Directed Electronics, Vista, CA G4203V 2008-09
  • Viper Responder One | Owner Manual - Page 2
  • Viper Responder One | Owner Manual - Page 3
    9 Important Information 9 System Maintenance 9 Your Warranty 9 Using Your System 10 Unlocking 10 Car Finder 10 Ignition Controlled Door Locks 10 Remote Start 11 Valet Take-Over 13 Programming options 14 Glossary of Terms 14 Quick Reference Guide 15 Limited lifetime consumer warranty 17
  • Viper Responder One | Owner Manual - Page 4
    installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept
  • Viper Responder One | Owner Manual - Page 5
    enclosed area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. It is the user installation guide. If the vehicle starts in gear, cease remote start operation immediately and consult with the authorized Directed dealer to fix the problem
  • Viper Responder One | Owner Manual - Page 6
    outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly reinstall the remote start system so that the
  • Viper Responder One | Owner Manual - Page 7
    of your remote start keyless entry system. This system has been designed to provide years of trouble-free operation. By carefully reading this owner's guide prior to using your system, you can maximize the use of this system and its features. Additional or replacement copies of this guide can be
  • Viper Responder One | Owner Manual - Page 8
    rocess. 2. Turn the circuit board over, remove batterieEslasftroommer clip and replace. contact Circuit Board ++ + ++ Note: Verify that the battery polarity is correct when replac- ing. Batteries are stacked in series and polarity is indicated. 3. Reposition all parts
  • Viper Responder One | Owner Manual - Page 9
    feature. ➢ Car Finder Before the vehicle is remotely started via the transmitter, press and hold the transmitter button for 3 seconds to activate the car finder function. The vehicle responds by flashing the parking lights 5 times slowly. The remote responds with 1 short beep and the orange LED on
  • Viper Responder One | Owner Manual - Page 10
    on the transmitter once. 2. The remote responds with the remote start On tones and the green LED on the remote flashes once. The vehicle's parking lights turn ON constant to confirm remote start operation. 3. Once the vehicle has started, it runs for the pre-programmed period of time (12, 24, or
  • Viper Responder One | Owner Manual - Page 11
    during remote start operation, the system monitors the vehicle and automatically shuts down the engine if the system receives any of the following shut-down inputs: • The brake pedal is pressed. • The hood is opened. • The shutdown toggle switch is put into the ON position. • The pre-programmed run
  • Viper Responder One | Owner Manual - Page 12
    . The remote responds with the remote start ON tones and the green LED on the remote flashes once. The vehicles parking lights turn on constant to confirm remote start operation. 2. Turn the ignition key to the OFF position. (The engine stays running.) 3. The engine runs until pre-programmed time
  • Viper Responder One | Owner Manual - Page 13
    settings in bold. • 12, 24, or 60 minute run time. Your system can be programmed to allow the vehicle to run for 12, 24, or 60 minutes when remote started. Can be set up to minute increments by your installer. • Parking lights flashing or constant. Your system can be pro- grammed to turn on
  • Viper Responder One | Owner Manual - Page 14
  • Viper Responder One | Owner Manual - Page 15
    purse or wallet for a quick and easy reference. Quick Reference Guide To remote start the vehicle • Press and release the transmitter button for 1-second. The remote responds with the remote start ON tones and the green LED on the remote flashes once. The parking lights turn on constant to confirm
  • Viper Responder One | Owner Manual - Page 16
  • Viper Responder One | Owner Manual - Page 17
    replace (at Directed's election) with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote remote transmitters and the associated sensors and accessories, carry a one , neglect, improper service, installation or other causes not
  • Viper Responder One | Owner Manual - Page 18
    THE MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE SUBJECT TO THE USE, NEGLIGENCE, ACTS OF GOD, NEGLECT, IMPROPER SERVICE, OR OTHER CAUSES NOT ARISING OUT OF DEFECT IN company name and address o Type of alarm installed o Year, make, model and color of
  • Viper Responder One | Owner Manual - Page 19
  • Viper Responder One | Owner Manual - Page 20
    is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call (800) 274-0200 for
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Responder One
Remote Start
Owner's Guide
© 2008 Directed Electronics, Vista, CA
G4203V 2008-09