Vtech Accessory Handset with Caller ID and Handset Speakerphone User Manual (C - Page 6

Getting started Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 10 hours of continuous charging. See the table on page 8 for battery operating times. If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset plays four short beeps and shows LOW BATTERY along with a flashing icon. When you are on a call in low battery mode, the handset plays four short beeps every 50 seconds. The following table summarizes the battery charge indicators and actions to take. Battery indicators Battery status Action The screen is blank, or shows PLACE IN CHARGER and flashes. Battery has no charge or very little charge. The handset cannot be used. Charge without interruption (at least 30 minutes). The screen shows LOW BATTERY and flashes. Battery has enough charge to be used for a short time. Charge without interruption (at least 30 minutes). The screen shows HANDSET X. Battery is charged. To keep the battery charged, place it in the telephone base or charger when not in use. If you place the handset in the telephone base or charger without plugging in a battery, the screen displays NO BATTERY. After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time. To skip setting the date and time, press OFF/CANCEL. SET DATE --/--/--