Vtech Go Go Smart Wheels Fast & Friendly Garage User Manual - Page 7
Instructions
View all Vtech Go Go Smart Wheels Fast & Friendly Garage manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
INSTRUCTIONS Battery Removal And Installation 1. Make sure the unit is turned OFF. 2. Find the battery cover located on the bottom of the Speedy Race Car, use a screwdriver to loosen the screw and then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AAA (AM-4/LR03) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended). 5. Replace the battery cover and tighten the screw to secure. MPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used. 7