Home » Vtech Manuals » Cordless Phones » Vtech T2418 » Manual Viewer

Vtech T2418 User Manual - Page 17

Additional, Information

UPC - 735078004314

Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

In Case Of Difficulty You Hear Noise In The Handset, And None Of The Keys Or Buttons Work • Make sure the power cord is plugged in. Common Cure For Electronic Equipment If the unit does not seem to be responding normally, then try putting the Handset in the cradle. If it does not seem to respond, do the following(in the order listed) : 1. Disconnect the power to the Base. 2. Disconnect the Handset battery. 3. Wait a few minutes. 4. Connect power to the Base. 5. Re-install the battery pack, and return the Handset to the charge cradle. 6. After a few seconds, try using your Handset again. 16 Additional Information

Section	Page
Table of Contents	1
Important Safety Instructions	2
Introduction	3
Parts Check List:	3
Handset and Base Layout	4
Getting Started	5
Setup	5
Connecting power to Base Unit	5
Installation of Battery Pack in Handset	5
Connecting to phone line	6
Checking for dial tone	6
Tone/Pulse Selection	6
Wall Mounting	7
1. Choose a spot near an electrical outlet and a telephone jack.	7
2. Mount the base on the wall.	7
3. Connect the telephone cord.	7
4. Connect the power cord.	7
Handset Features	8
IN USE/LOW BATT LED	8
PHONE / FLASH KEY	8
REDIAL / PAUSE KEY	8
TONE/ * KEY	8
PROG KEY	8
VOLUME CONTROL	8
OFF KEY	8
CHAN KEY	8
MEM KEY	8
Base Unit Features	9
IN USE/ CHARGING LED	9
PAGE KEY	9
Basic Operation	10
Operating Instructions	10
Making Calls	10
Answering Calls	10
Disconnecting	10
Changing Channels	11
TONE/PULSE Setting	11
Temporary Tone	11
Programming the Ringer Type	11
Turning Off the Ringer	11
Checking the Ringer	12
Memory Dialing	12
Programming Speed Dial Numbers	12
Speed Number Dialing	12
To Change or Replace a Speed Dial Number	12
Storing Pauses in Memory	13
Using Redial	13
Storing a Redial Number into Speed Dial	13
The Page Feature	13
Additional Information	14
Headset Operation	14
To purchase a Headset,	14
Belt Clip	14
Maintenance	15
In Case Of Difficulty	16
The Phone Doesn't Work At All	16
No Dial Tone	16
You Get Noise, Static, Or A Weak Signal Even When You're Near The Base Unit	16
You Get Noise, Static, Or A Weak Signal When You're Away From The Base Unit	16
The Handset Does Not Ring When You Receive A Call	16
You Hear Other Calls While Using Your Phone	16
You Hear Noise In The Handset, And None Of The Keys Or Buttons Work	17
Common Cure For Electronic Equipment	17
Warranty Statement	18
FCC, ACTA and IC Regulations	21
The RBRC® Seal	24