Weber Ducane Affinity 3200 LP Owner Manual - Page 23

Troubleshooting

Get Weber Ducane Affinity 3200 LP PDF manuals and user guides View all Weber Ducane Affinity 3200 LP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

TROUBLESHOOTING PROBLEM ELECTRONIC IGNITION MAIN GRILLING BURNERS BURNERS WITH POOR FLAME CHECK and CURE IMPORTANT Be sure you have a fresh battery installed. Be sure that there is gas flow to the burners by attempting to match light your burners. If match lighting is successful, the problem lies somewhere in the ignition system and will need to be checked. • Check that all wires are connected to the ignition box (1). • Be sure that wires are correctly inserted into teminals (2) on ignition box. Verify that the battery is in good condition and installed correctly. If for any reason the igniter system is still inoperative, follow match lighting instructions. ƽ CAUTION: Always turn the gas supply off at the tank before proceeding with any troubleshooting procedures. ƽ WARNING: The hood must be in the full open position any time you attempt to light your grill. Failure to open the hood could lead to delayed ignition, resulting in bodily harm. After shutting off the main gas supply, remove the cook grate and heat distribution plates. Push the igniter button and check if the electrode is sparking to the igniter tube. Try pushing and holding the igniter so that it clicks several times. If the main burner(s) still fails to ignite, make sure that there is gas flowing to the burner(s) by attempting to match light the burner(s). If the burners will match light, then proceed with the ignition checkout. If for any reason the igniter system is still inoperative, follow match lighting instructions. Check to be sure burner ports, shutter, end of the burner (venturi) and orifice(s) are free of any obstructions. Also, if your grill has been stored over a prolonged period of time, check to make sure no spiderwebs have been formed in the shutter end of the burner (venturi) or over orifices. If you still have a poor flame, please contact dealer for futher assistance or call Customer Service at 1-800-382-2637. On an LP grill, if an extremely low flame is present, or is hard to ignite, the flow-limiting device may have activated. To reset the flow limiter turn all burners control knobs to "HI". Wait at least 1 minute. Turn burner control knobs "OFF", reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to Lighting Insructions. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area by calling 1-800-382-2637. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
23
PROBLEM
CHECK and CURE
IMPORTANT
ELECTRONIC IGNITION
Be sure you have a fresh battery installed.
Be sure that there is gas flow to the burners by attempting to match light your burners. If match
lighting is successful, the problem lies somewhere in the ignition system and will need to be
checked.
• Check that all wires are connected to the ignition box
(1)
.
• Be sure that wires are correctly inserted into teminals
(2)
on ignition box.
Verify that the battery is in good condition
and installed correctly.
If for any reason the igniter system is still
inoperative, follow match lighting instructions.
MAIN GRILLING BURNERS
±
CAUTION: Always turn the gas supply off at the tank before
proceeding with any troubleshooting procedures.
±
WARNING: The hood must be in the full open position any time you
attempt to light your grill. Failure to open the hood could lead to
delayed ignition, resulting in bodily harm.
After shutting off the main gas supply, remove the cook grate and heat distribution plates. Push
the igniter button and check if the electrode is sparking to the igniter tube. Try pushing and
holding the igniter so that it clicks several times.
If the main burner(s) still fails to ignite, make
sure that there is gas flowing to the burner(s)
by attempting to match light the burner(s).
If the burners will match light, then proceed
with the ignition checkout.
If for any reason the igniter system is still
inoperative, follow match lighting instructions.
BURNERS WITH POOR FLAME
Check to be sure burner ports, shutter, end of the burner (venturi) and orifice(s) are free of any
obstructions. Also, if your grill has been stored over a prolonged period of time, check to make
sure no spiderwebs have been formed in the shutter end of the burner (venturi) or over orifices.
On an LP grill, if an extremely low flame is present, or is hard to ignite, the flow-limiting device
may have activated. To reset the flow limiter turn all burners control knobs to “HI”. Wait at least
1 minute. Turn burner control knobs “OFF”, reconnect the regulator to the cylinder. Turn cylinder
valve on slowly. Refer to Lighting Insructions.
If you still have a poor flame, please contact
dealer for futher assistance or call Customer
Service at 1-800-382-2637.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area by calling 1-800-382-2637.
TROUBLESHOOTING
TROUBLESHOOTING