Weber Genesis 2 LP Owner Manual - Page 13

Step 8 Install manifold bracket You will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the bracket, manifold and cooking box slightly as a unit and hook onto the frame brace. Manifold bracket Frame brace Step 9 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system. The igniter lock nut is on the igniter. Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 10 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 10 (c). Tighten the igniter lock nut. Figure 10. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. Figure 9 (a) Frame brace (b) Figure 10 Keyhole in Igniter lock nut frame brace Frame brace (c) Small part of keyhole in frame brace 13