Weber Genesis E-320 LP Owner Manual - Page 16
Operating Instructions, Troubleshooting
View all Weber Genesis E-320 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 OPERATING INSTRUCTIONS MANUALLY LIGHTING THE SIDE BURNER ƽ DANGER Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive flare-up that can cause serious bodily injury or death. 320 1) Open the side burner lid. 2) Check that the side burner valve is turned off (Push control knob in and turn clockwise to ensure that it is in the "OFF" position), turn all burners not being used to the "OFF" position (push in and turn clockwise). 3) Turn the gas supply valve on. 4) Put match in a match holder and strike match. 5) Hold match holder and lit match by either side of the side burner. 6) Push down and turn the side burner control valve to "HI". ƽ CAUTION: Side burner flame may be difficult to see on a bright sunny day. ƽ WARNING: If the side burner does not light in five (5) seconds: a) Turn off the side burner control valve, main burners and gas supply at source. b) Wait 5 minutes to let the gas clear before you try again. PROBLEM Burners burn with a yellow or orange flame, in conjunction with the smell of gas. TROUBLESHOOTING CHECK Inspect Spider/Insect Screens for possible obstructions. (Blockage of holes.) CURE Clean Spider/Insect Screens. (See Section "Annual Maintenance") Symptoms: Burners do not light. -or- Burners have a small flickering flame in the "HI" position. -orBarbecue temperature only reaches 250˚ to 300˚ in the "HI" position. Burner does not light, or flame is low in "HI" position. Experiencing flare-ups: The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. Is LP fuel low or empty? Is fuel hose bent or kinked? Does Burner 1 light with a match? Are you preheating barbecue in the prescribed manner? To reset the excess flow safety device turn all burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to "HI". Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". Refill LP cylinder. Straighten fuel hose. If you can light Burner 1 with a match, then check the Crossover® ignition system. All burners on HI for 10 to 15 minutes for preheating. Are the cooking grates and Flavorizer® bars heavily coated with burned-on grease? Clean thoroughly. (See Section "Cleaning") ƽ CAUTION: Do not line the bottom tray with aluminum foil. Is the bottom tray "dirty" and not allowing grease to flow into catch pan? Clean bottom tray. Burner flame pattern is erratic. Flame is low when burner is on "HI". Flames do not run the whole length of the burner tube. Are burners clean? Clean burners. (See Section "Maintenance".) Inside of lid appears to be "peeling." (Resembles paint peeling.) The lid is porcelain enamel or stainless steel, not paint. It cannot "peel". What you are seeing is baked on grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. (See Section "Cleaning".) Cabinet doors are not aligned. Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide door/s until aligned. Tighten nut. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. WWW.WEBER.COM®