Weber Genesis Silver A NG Owner Manual - Page 14

Install manifold bracket You will need: manifold bracket. Hook the bracket(2) onto the manifold in the center. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly, then hook the tab of the bracket onto the frame brace(1). (1) (2) Install frame connector You will need: frame connector, two 1 3/4 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench. Add nylon washer to the bolt, insert bolt through the hole in the bottom center of the wheel frame and into the end of the frame connector(1). Insert the other bolt with a washer on it through the leg frame and into the other end of the frame connector. Hold the frame connector square and tighten the bolts with the wrench. Install Gas Supply General Specifications for Piping Note - Contact your local municipality for building codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must confirm to the latest edition of ANSI Z223.1. WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL. Some of the following are general requirements taken from ANISI Z223.1 latest edition for complete specifications. s This barbecue is designed to operate at 7 inches of water column pressure (.2526 psi). s A manual shut-off valve must be installed outdoors, immediately ahead of the quick disconnect. s An additional manual shut-off valve indoors should be installed in the branch fuel line in an accessible location near the supply line s The quick disconnect connects to a 3/8 inch NPT thread from the gas source. The quick disconnect fitting is a hand-operated device that automatically shuts OFF the flow of gas from the source when the barbecue is disconnected s The quick disconnect fitting can be installed horizontally, or pointing downward. Installing the fitting with the open end pointing upward can result in collecting water and debris. s The dust covers (supplied plastic plugs) help keep the open ends of the quick disconnect fitting clean while disconnected. s Pipe compound should be used which is resistant to the action of natural gas when connections are made. s The outdoor connector must be firmly attached to rigid, permanent construction. ƽ WARNING: Do not route the 12 foot hose under a deck. The hose must be visible. (1) B-4