Weber Summit S-620 NG Owner Manual - Page 28

28 OPERATING INSTRUCTIONS OPERATING THE HANDLE LIGHT The Weber Grill Out™ Handle Light has a built-in "Tilt Sensor." With the power button (a) activated, the light will come on when the grill lid is open. The light will turn off when the lid is closed. For daytime use, deactivate the sensor by pressing power button (a). HANDLE LIGHT TROUBLESHOOTING PROBLEM CHECK CURE Weber Grill Out™ Handle Light does not light. Are the batteries old? Are the batteries installed correctly? Is the lid in the up position with the power button ON? Replace batteries. See assembly illustration. Light will activate when lid is open. Is the Weber Grill Out™ Handle Light activated? Press the power button. Is the Weber Grill Out™ Handle Light positioned correctly on the handle? Adjust position (See assembly illustration). If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. ROTISSERIE TROUBLESHOOTING PROBLEM Rotisserie burner does not light. CHECK Did you hold the burner control knob in and hold in for 20 seconds until after burner ignited? Did you wait to see the entire ceramic surface become alight before counting 20 seconds? Did you repeatedly use the snap ignition until the burner ignited? Does the igniter work (Do you see a spark when you repeatedly use the snap igniter? CURE Try to relight burner by holding burner control knob in and continue holding in until 20 seconds after burner has ignited. When relighting burner by holding burner control knob in, wait to see the entire ceramic surface become alight before counting 20 seconds? After waiting five minutes for gas to clear, try repeatedly using the snap igniter until the burner ignites (refer to "Lighting the Rotisserie Burner"). Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call customer service. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. PROBLEM Side Burner does not light. SIDE BURNER TROUBLESHOOTING Is gas supply off? CHECK Turn supply on. CURE Flame is low in "HI" position Push button ignition does not work. Is the fuel hose bent or kinked? Does burner light with a match? Straighten hose. If match lights burner, check igniter (see below). If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. WWW.WEBER.COM®