Weider 14933 Instruction Manual - Page 12
attach two Half Guards 35, the Pulley Plates
View all Weider 14933 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12. Route the Short Cable (31) over a Pulley (32). 12 Attach the Pulley (32) inside the Center Frame (7) with an M10 x 55mm Bolt (40), two M10 Washers (55), two Pulley Bushings (38), and an M10 Locknut (47). Make sure to leave slack in the Short Cable (31) in the indicated location. 13. Insert a Pulley (32) into the loop of the Short Cable (31) as shown. 13 Orient two Pulley Plates (34) as shown. Using the first hole in the Pulley Plates (34), attach two Half Guards (35), the Pulley Plates, and a Cable Trap (33) to the Pulley (32) with an M10 x 50mm Bolt (46) and an M10 Locknut (47). Make sure that the Cable Trap (33) is oriented to hold the Short Cable (31) in the groove of the Pulley (32). 14. Attach the end of the Short Cable (31) to the Weight Carriage (10) with an M10 x 15mm 14 Screw (50). 47 55 38 32 7 38 55 40 31 Slack 47 35 31 32 33 35 46 34 31 50 10 12