Weider 350 Bench English Manual - Page 9

10. Orient the Center Base (24) so that the indented holes are downward. Insert two M10 x 62mm Carriage Bolts (97) up through the Center Base. Locate the Side Base (51) that has a warning decal. Orient the Side Base as shown and attach it to the Center Base (24) with two M10 x 68mm Bolts (85), two M10 Washers (83), and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. Attach the other Side Base (51) in the same way. 11. Attach the Center Upright (26) to the Center Base (24) with two M10 x 62mm Carriage Bolts (97) and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. Attach the Foot Plate (46), the Center Upright (26), and the Rear Base (25) to the Center Base (24) with two M10 x 75mm Bolts (39) and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. Attach the Foot Plate (46) to the Center Upright (26) with an M10 x 68mm Bolt (85), an M10 Washer (83), and an M10 Nylon Locknut (80). 10 Indented Holes 97 24 85 51 85 Warning Decal 83 83 80 11 26 12. Attach the Butterfly Frame (32) to the Center Upright (26) with two M10 x 68mm bolts (85), the Plate (41), and two M10 Nylon Locknuts (80). 46 85 80 24 97 39 12 26 80 32 83 25 80 80 85 41 80 9