Weider Club 8980 W English Manual - Page 11

11. Attach the Press Arm (8) without the wire to the Upright (3) with four M10 x 25mm Screws (58). Remove the M4 x 5mm Screw (69) and the Swivel Arm (16). Route the Press Arm Cable (30) through the Swivel Arm and the Press Arm (8) as shown. Reattach the Swivel Arm (16) to the Press Arm (8) with the M4 x 5mm Screw (69). 11 3 12. Attach a V-pulley (22) to a Swivel Arm (16) with an M10 x 64mm Button Bolt (75), two M10 12 Washers (71), two 5mm Spacers (25), and an M10 Locknut (73). Make sure that the Press Arm Cable (30) is routed under the indicated welded rods. 8 58 16 30 69 58 Welded 16 Rod 71 25 71 73 30 75 25 Welded 22 Rod 13. Attach a 2 3/4" Pulley (23) to the left Press Arm (8) with an M10 x 53mm Button Bolt (61), two M10 Washers (71), two 5mm Spacers (25), two Guards (27), and an M10 Locknut (73). See the inset drawing. Orient the Guards and the Pulley as shown. Make sure that the Press Arm Cable (30) is in the groove of the Pulley. 13 27 27 27 23 23 73 30 71 27 25 25 71 8 61 11