Weider Pro 400 Bench English Manual - Page 5
Assembly
View all Weider Pro 400 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Assembly Before beginning assembly, carefully read the following information and instructions: ¥ Assembly requires two people. ¥ Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ As you assemble the weight rack, make sure all parts are oriented as shown in the drawings. The following tools (not included) may be required for assembly: ¥ Two (2) adjustable wrenches ¥ One (1) rubber mallet ¥ One (1) standard screwdriver ¥ One (1) phillips screwdriver Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches or a set of ratchet wrenches. M10 x 80mm Bolt (4)Ð32 M10 x 75mm Bolt (15)Ð2 1. Press 60mm Square Inner Caps (14) onto the ends of the Right and Left Bases (1, 3). Attach the Right and Left Bases (1, 3) to the Center Base (2) using four M10 x 80mm Bolts (4) and four M10 Nylon Locknuts (9). Do not tighten the Nylon Locknuts yet. 2. Identify the two Rear Uprights (8), which are slightly shorter than the Front Uprights (not shown). Attach the Rear Uprights (8) to the Left and Right Bases (1, 3) using four M10 x 80mm Bolts (4) and four M10 Nylon Locknuts (9). Do not tighten the Nylon Locknuts yet. Make sure the Uprights are oriented exactly as shown, with the adjustment holes on the indicated side near the bottom. Attach the Foot Plate (5) to the Center Base (2) using two M10 x 75mm Bolts (15), two M10 Washers (19), and two M10 Nylon Locknuts (9). Do not tighten the Nylon Locknuts yet. 1 14 9 4 1 2 14 4 3 14 9 14 2 8 4 1 Adjustment Holes 8 9 2 19 9 19 15 5 3 5