Weider Pro 9935 English Manual - Page 8
Nylon Locknut; the Leg Press Lever must pivot
View all Weider Pro 9935 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
9. Press a 2Ó Square Inner Cap (28) into the Press Seat 9 Frame (7). Slide the bracket on the Press Seat Frame (7) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16Ó Nylon 28 Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet. 64 Attach the Press Seat Frame (7) to the Press Upright (2) with two 5/16Ó x 2 3/4Ó Bolts (89), two 5/16Ó Washers (36), and two 5/16Ó Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet. 10. Lubricate the 3/8Ó x 3Ó Bolt (88). Attach the Leg Press 10 Lever (83) to the Press Base (6) with the Bolt and a 3/8Ó Nylon Locknut (50). Do not overtighten the Nylon Locknut; the Leg Press Lever must pivot easily. 89 36 7 64 36 89 64 2 6 92 83 50 11. Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide (15) into each of the holes. Attach the indicated Weight Guide (15) to the Weight Base (5) with a 3/8Ó x 2 3/4Ó Bolt (46), two 3/8Ó Flat Washers (48), and a 3/8Ó Nylon Locknut (50). Slide six Weights (21) onto the Weight Guides (15). Make sure the Weights are turned so the pin grooves point towards the floor. Press a Weight Tube Bumper (18) into the lower end of the Short Weight Tube (17). Slide the Weight Tube into the center holes in the Weights (21). Slide a Top Weight (16) onto the Weight Guides (15). Note: Make sure the Top Weight is turned so the groove fits over the welded pin on the Weight Tube (17). 11 15 16 Groove Pin 17 21 Pin Grooves 5 48 46 8 6 Lubricate 88 18 51 48 50