Weider Pro Xt75 English Manual - Page 9
Attach the Weight Guides to the Weight Guide - cables & pulleys
View all Weider Pro Xt75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
10. Press a 60mm Square Inner Cap (29) into the end of the Weight Guide Frame (14). Hold the Weight Guide Frame (14) on top of the Center Frame (11) and the Weight Guides (9). Attach the Weight Guides to the Weight Guide Frame using two M8 x 72mm Bolts (35), four M8 Flat Washers (40), and two M8 Nylon Locknuts (32). Attach the Weight Guide Frame (14) to the Center Frame (11) using two M10 x 78mm Bolts (33), two M10 Flat Washers (41), and two M10 Nylon Locknuts (31). 11. Locate the High Cable (26), which is the longer of the two Cables. Notice that there is a single ball on one end of the High Cable and a metal sleeve on the other end. Route the metal-sleeve end of the High Cable (26) up under the lat bar rest on the Weight Guide Frame (14), down through the indicated hole, back up through the next hole, and then down through the hole between the Weight Guides (9), as shown. 10 32 40 33 14 11 41 31 11 Lat Bar Rest 26 29 40 35 9 14 9 12. Insert the end of the High Cable (26) into the hole in the center of the Weight Carriage (15). Attach the 12 High Cable using an M10 x 66mm Bolt (37), two M10 Flat Washers (41), two 24mm Spacers (42), and an M10 Nylon Locknut (31). 31 41 42 15 26 42 41 37 13. Lift the High Cable (26) in the location shown. Attach two Pulleys (25) inside the bracket on the 13 Weight Guide Frame (14) using two M10 x 50mm Bolts (47) and two M10 Nylon Locknuts (31). 9 25 31 26 14 47