Weslo 10pi English Manual - Page 5
Assembly
View all Weslo 10pi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires an 8" adjustable wrench and a standard screwdriver (not included). 1. Remove the cardboard tube from the Lock Knob (31), and slide the Lock Knob Washer (30) onto the Lock Knob. Raise the Upright Post (9) to a vertical position. 9 31 Be careful not to pinch your fingers. Insert the Lock 30 Knob into the Upright Post and turn the Knob clockwise until it is almost tight. Leave a little play in the Upright Post for the following steps. 2. Align the upper end of the Side Rail (1) with the left end of the Handrail (10). Turn the Handrail in the direction shown to thread the Handrail into the Side Rail. (Note: If the Handrail will not turn easily, loosen the Handrail Bolt [7] slightly.) lighten the Handrail and the Handrail Bolt. 3. Align the lower end of the Side Rail (1) with the hole in the side of the treadmill Frame (54). Insert the Side Rail Bolt (81) through the Side Rail and Frame. Reach under the Frame and tighten the Side Rail Nut (82) onto the end of the Bolt. Tighten the Lock Knob (see step 1). 10 7 81 54 4. Remove the backing from the Wrench Clip (74), and press it onto the Right Endcap (72) in the indicated location. Press the Allen Wrench (73) into the Wrench Clip. 82 72 0 73 74 5. Slide the metal Clothes Clip (4) onto the Pulse Earclip (5) in the indicated location. The use of the Pulse 5. 5 Earclip is explained in SELECTING MONITOR MODES 4 on page 9. 5 Make sure that all parts are tightened securely before using the treadmill. 4 5