Weslo 16 Instruction Manual - Page 8

5. Attach the Latch Housing (72) to the Left Upright (73) with two #10 x 1" Tek Screws (83); start 5 both Screws, and then tighten each of them. 73 72 83 6. Identify the rod end of the Gas Spring (85). See the two small inset drawings. Locate the 6 Spring Clip (86) in the rod end of the Gas Spring. Using your fingernail or a screwdriver, press on the end of the Spring Clip to loosen it. Rotate the Spring Clip, and then pull the Spring Clip out of the Gas Spring. Avoid losing the Spring Clip. Extra Spring Clips are included. Next, press the rod end of the Gas Spring (85) as far as possible onto the Mount (92) on the bracket in the center of the Frame (50). See drawing 6a. Insert the Spring Clip (86) into the two indicated small holes in the rod end of 6a the Gas Spring (85). Then, rotate the Spring Clip until it clips onto the Gas Spring. 50 Bracket 86 Rod 85 86 86 92 86 Holes 50 85 7. Remove the Spring Clip (86) from the lower end of the Gas Spring (85). Press the lower 7 end of the Gas Spring onto the Mount (92) on the bracket in the center of the Base (80). Note: It may be necessary to pivot the Frame (not shown) forward or backward slightly.  See drawing 7a. Insert the Spring Clip (86) into the two indicated small holes in the Gas Spring (85). Rotate the Spring Clip until it clips onto the Gas Spring. 7a Lower the treadmill. See HOW TO LOWER THE TREADMILL FOR USE on page 15. 85 86 80 Bracket 85 86 80 92 Holes Bracket 8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see pages 17 and 18). To protect the floor or carpet, place a mat under the treadmill. 8