Weslo 330i Treadmill Canadian English Manual - Page 8

4. Cut the tie securing the upper end of the Wire Harness (17). Have a second person hold the Console (78) near the Right Upright (10). Attach the ground wire from the Console to the Right Upright with the 1/2" Silver Screw (87). Connect the Wire Harness (17) to the wire harness on the Console (78). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors into the Console. 5. Set the Console (78) on the Left and Right Uprights (9, 10). Be careful not to pinch any wires. See drawing 4 above. Make sure that the Wire Harness (17) is not in the small cutout shown by the arrow. Attach the Console (78) to the Uprights (9, 10) with six 3/4" Screws (70). Start all six Screws before tightening any of them; be careful not to overtighten the Screws. 4 78 Ground Wire 87 17 10 5 78 70 10 70 17 9 70 6. Lower the Uprights (9, 10) until the handrails are touching the floor. 6 See the lower drawing. Position the Uprights (9, 10) so that the treadmill Frame (12) is centered between them. Firmly tighten the four 3" Bolts (47). Then, raise the Uprights (9, 10) back to the vertical position. Handrail 47 9, 10 Top View 10 9 12 8