Weslo Cadence 200 Instruction Manual

Weslo Cadence 200 Manual

Get Weslo Cadence 200 PDF manuals and user guides View all Weslo Cadence 200 manuals
Add to My Manuals
Save this manual to your list of manuals

Weslo Cadence 200 manual content summary:

  • Weslo Cadence 200 | Instruction Manual - Page 1
    give the following information: • the MODEL NUMBER of the product (WETL14805.1) • the NAME of the product (WESLO CADENCE 200 treadmill) • the SERIAL NUMBER of the product (see the front cover of this manual) • the KEY NUMBER and DESCRIPTION of the desired part(s) (see the PART LIST and the EXPLODED
  • Weslo Cadence 200 | Instruction Manual - Page 2
    THE TREADMILL 14 TROUBLESHOOTING 16 CONDITIONING GUIDELINES 18 ORDERING REPLACEMENT PARTS Back Cover Note: A PART IDENTIFICATION CHART, an EXPLODED DRAWING, and a PART LIST are attached in the center of this manual WESLO is a registered trademark of ICON IP, Inc. 2 19
  • Weslo Cadence 200 | Instruction Manual - Page 3
    your heart rate as a guide. The chart below shows help prevent postexercise problems. EXERCISE FREQUENCY To treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See TROUBLESHOOTING if the treadmill is not working properly.) 14. Never start the treadmill
  • Weslo Cadence 200 | Instruction Manual - Page 4
    procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only. 24. This treadmill is intended for in
  • Weslo Cadence 200 | Instruction Manual - Page 5
    TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM new WESLO® CADENCE 200 treadmill. The CADENCE 200 treadmill is
  • Weslo Cadence 200 | Instruction Manual - Page 6
    , and needlenose pliers . , two To identify the assembly hardware, see the PART IDENTIFICATION CHART in the center of this manual. WARNING: Do not plug in the power cord until the treadmill is completely assembled. 1. Orient the Base (46) so the holes for the four Base Pads (63) are on top
  • Weslo Cadence 200 | Instruction Manual - Page 7
    lift 45 pounds (20 kg) to raise, lower or move the treadmill. 1. Hold the treadmill with your hands in the location shown by the arrow at the right Frame. Do not tighten the Bolt yet. Repeat this step on the left side of the treadmill. 27 79 27 3 70 46 29 66 70 5. Locate the Wire Harness (60).
  • Weslo Cadence 200 | Instruction Manual - Page 8
    ; there are four incline levels. Before changing the incline, remove the key and unplug the power cord. Next, fold the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 14). To change the incline, first remove the incline pin from one of the incline legs as
  • Weslo Cadence 200 | Instruction Manual - Page 9
    are touching the 10 floor. See 10a. Position the Handrails (53, 59) so the treadmill Frame (79) is centered between them. Firmly tighten the four 2 1/2" Bolts (65), all parts used in assembly are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the
  • Weslo Cadence 200 | Instruction Manual - Page 10
    . The first time the treadmill is used, observe the alignment of the walking belt, and center the walking belt if necessary (see page 17). GR 1 Insert the key fully into the console. See the instructions at the left. 2 Start the walking belt. To start the walking belt, press the Speed increase
  • Weslo Cadence 200 | Instruction Manual - Page 11
    2 Incline Leg Washer 62 4 2" Bolt 13 3 14 2 15 4 Wheel Nut Belt Guide Belt Guide Screw 63 4 64 1 65 4 Base Pad Hex Key 2 1/2" Bolt Spacer Screw (45 without notice. See the back cover of the user's manual for information about ordering replacement parts. PART IDENTIFICATION CHART
  • Weslo Cadence 200 | Instruction Manual - Page 12
    EXPLODED DRAWING-Model No. WETL14805.1 R0905A 1 3 51 52 54 55 6 3 3 22 24 25 78 69 2 41 71 25 2 50 4 20 22 67 3 8 32 7 14 15 76 23 27 19 3 3 16 13 47 21 10 9 77 10 9 72 74 26 17 3 18 21 3 18 11 75 45 10 3873 3 38 58 3 9 80 64 38 43 11 49 85 40 3 12 82 81 38
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
Model No. WETL14805.1
Serial No.
Write the serial number in the
space above for future reference.
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
USER'S MANUAL
Serial
Number
Decal
Part No. 229249 R0905A
Printed in Canada © 2005 ICON IP, Inc.
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete
customer satisfaction. If you
have questions, or if there are
missing or damaged parts,
please call:
or write:
ICON Health & Fitness, Ltd.
Customer Service Department
Unit 4
Revie Road Industrial Estate
Revie Road
Beeston
Leeds, LS118JG
UK
08457 089 009
ORDERING REPLACEMENT PARTS
To order replacement parts, contact the ICON Health & Fitness, Ltd. office, or write:
ICON Health & Fitness, Ltd.
Customer Service Department
Unit 4, Revie Road Industrial Estate
Revie Road
Beeston
Leeds, LS118JG
UK
Tel:
Outside the UK: 0 (044) 113 387 7133
Fax: 0 (044) 113 387 7125
To help us assist you, please be prepared to give the following information:
•
the MODEL NUMBER of the product (WETL14805.1)
•
the NAME of the product (WESLO CADENCE 200 treadmill)
•
the SERIAL NUMBER of the product (see the front cover of this manual)
•
the KEY NUMBER and DESCRIPTION of the desired part(s) (see the PART LIST and the EXPLODED DRAW-
ING in the centre of this manual)
08457 089 009